High cost performance outstanding liquid outstanding performance
Butyl rubber machine
Adjustment and function of internal parameters
Front wheel pressing down: refers to the time when the front part
of the aluminum frame is pressed down after the induction signal
delay after the butyl photoelectric switch.
Front wheel lift: refers to the lifting of the front pressure wheel
after the rear end of the aluminum frame leaves the gluing
photoelectric switch without the time of induction signal delay set
by this parameter.Gluing start: refers to when the front section of
the aluminum frame after gluing photoelectric switch, with the
induction signal delay this parameter set time, the gluing switch
opened to start gluing.The end of gluing: refers to when the front
section of the aluminum frame left the gluing photoelectric switch,
there is no induction signal delay this parameter set time, the
gluing switch off to stop gluing.After the pressure wheel down:
refers to when the aluminum frame front section after the butyl
photoelectric switch, with the induction signal delay this
parameter set time, after the pressure wheel down.Rear pressure
wheel lifting: refers to the rear pressure wheel lifting when the
rear end of the aluminum frame leaves the gluing photoelectric
switch and there is no time for the induction signal delay
parameter setting.Arc delay butyl: when arc butyl, delay butyl time
after stepping on the foot.Special-shaped medium pressure wheel
delay time: when special-shaped gluing, after stepping on the foot,
the delay time of the middle pressure wheel fall.Special-shaped
delay butyl: when special-shaped butyl, release the foot after the
butyl mouth delay butyl time.
Adjustment of butyl pressure
Adjusting the pressure of the air source can adjust the pressure of
the hydraulic main system. Generally in 0.4 0.4 MPa
Adjust the pressure reducing valve handle to adjust the size of the
gluing pressure.Aluminum bar, will need to work on the rubber mouth
on the right side of the rubber mouth ranging micro switch, the
following article metal detector to detect aluminum, rubber mouth
automatically move, back after 1 to 2 seconds to aluminum bar in
front of micro switch, rubber mouth will automatically move
forward, after the baffle to promote aluminum strip run into micro
switch, with the signal and stop automatically, automatic adjust
the rubber mouth width is complete.
Click the switch button and pull the handle of the rubber cylinder
by hand after the piston exits. Put the butyl block into the butyl
cylinder, clean up the butyl cylinder base and brush some
lubricating oil, then press the butyl cylinder and click the butyl
cylinder into button.The photoelectric switch is a pair of
photoelectric switch, the aluminum bar through the two probes
directly block the signal between the transmission, butyl glue
began to work, the installation of the two probes should be
aligned, not too much deviation.
Technical data
| Squeeze pressure | 10-18MPa |
| Temperature | 110~140℃ |
| Aluminum spacer width | 4-30mm |
| Speed | 0-47m/min |
| Diameter of butyl cylinder | 200mm |
| Air supply | 0.4m³/min |
| Air pressure | ≥0.6MPa |
| Total power | 380V, 5KW, 50HZ |
| Dimension | 2600×680×1100mm(L×W×H) |
| Weight | 650kg |
