Affordable entry-level butyl rubber machine butyl machine,green
Adjustment and function of internal parameters
After using for a long time, the belt will become loose. Adjust the
tightening adjustment screw to adjust the tightening of the
belt.The pressure wheel can be adjusted through the fixed seat of
the cylinder.The extension Angle can also be adjusted by the
cylinder telescopic rodBelt deviation causes aluminum frame
deviation, adjust the belt tightening screws, adjust the belt.
After the pressing wheel falls, the direction of the pressing wheel
and the belt transmission are not perpendicular, which causes the
pressing wheel to run off with the aluminum strip.Check whether the
travel switch is firmly installed and has output signal, and
whether the movable bending plate of the aluminum strip with thick
side is firmly installed and it is required that the movable
bending plate is parallel to the guide guard plate. Whether the
piston of the small oil cylinder can be telescopic, and can be
telescopic in place, stroke 25mm. If not fully telescopic, check
whether the small oil cylinder fastening screw is loose or whether
the piston rod deformation stuck, check whether the throttle valve
adjusting position is appropriate. Under the condition of the above
three problems, the pressure regulating valve handle of the
adjustment panel is removed to remove the pressure. Under the
condition of heating, the system will place the aluminum strip
between the rubber nozzle, rotate the adjusting hand wheel to
adjust the rubber nozzle to an appropriate position, and then
re-thicken the side.
if need to change the sealing ring of the glue seat here, specific
operation, adjust the panel handle removing the pressure regulating
valve, rubber mouth temperature under the condition of 40-50
degrees, open glue seat six fixed screw, flipped open the slider
below slotted line copper pad, notice need not hurt bad copper pad,
dismantle the broken seal, the glue, the seat of the glue is clean
install new seal, pressure on the copper pad, can be installed on
glue
Troubleshooting and maintenance of equipment
1.Butyl rubber cylinder cannot advance in place
2.When the piston of the oil cylinder is fully retracted, oil comes
out of the hydraulic station
3.Air spring cannot be positioned (light displacement after the
back of butyl rubber cylinder)
4.The air spring does not extend itself
5.The glue is not even, broken flow, aluminum frame can not glue
6.In the automatic state, the pressure wheel does not press, the
rubber mouth does not glue
7.The photoelectric signal is unstable, which leads to the break of
the glue
8.The aluminum frame is out of alignment during gluing
9.Thickness measurement is inaccurate
10.The rubber mouth appears to be porous butyl gum
11.Glue base or leakage of glue
12.The booster pump frequently fails to work under pressure
Technical data
| Squeeze pressure | 10-18MPa |
| Temperature | 110~140℃ |
| Aluminum spacer width | 4-30mm |
| Speed | 0-47m/min |
| Diameter of butyl cylinder | 200mm |
| Air supply | 0.4m³/min |
| Air pressure | ≥0.6MPa |
| Total power | 380V, 5KW, 50HZ |
| Dimension | 2600×680×1100mm(L×W×H) |
| Weight | 650kg |
