Q345B Steel 3.2M Construction Material Hoist
Construction Material Hoist Main Parts
1. The gearing adopts imported bearing, enameled cable, and oil
seal.
2. The electric parts adopt products from world renowned
manufactures.
3. The racks and pinion adopts special material and heat-treatment
technique, which prolong the life of these parts.
4. The steel structure uses quality steel from famous domestic
manufactures.
5. The surface of the structure can apply paint-spray, parkerozing
baking finish or hot galvanizing processing according to users
requirements,
6. The cage can be produced and decorated by aluminum molded board,
punched-plate or figured aluminm board.
Production and Materials
KANGBO implements the true modular design of rack and pinion
hoists, standardization and fine finishing of lifts parts and spare
parts, and assembly line production. The construction material
elevator components are versatile and universal.
The construction material elevator structural parts are made of
16Mn and Q345 high strength steel.
The construction lift cage roof is made by a full steel plate, and
the edges are totally welded, to ensure no water leakage and high
strength.
Standard Configuration
There is a electrical small crane available to facilitate the
assembly of columns and doors on the floors.
Available in single or twin hoist cage configuration.
The Variable Frequency Drive (VFD) construction elevator are with
low starting current and much less wear and tear, very smooth
starting and stopping.
Lighting inside construction elevator car is LED ceiling lamp
The construction material hoist cage roof doors are equipped with
Interlock.
Equipped with hoist drop test facility with remote control.
Manual or Automatic Controls of the hoist is optional.
| Technical Data | Construction Material Hoist Rack Pinion Elevator SC200/200BG
KP-B09B10 |
| Payload capacity | 2,000 kg |
| Lifting speed | 0–60 m/min. |
| Max. lifting height | 250/400 m* |
| Cage width (internal) | 1.5 m |
| Cage length (internal) | 3.2 m |
| Cage height (internal) | 2.35 m |
| Motor control | FC control |
| Engine power | 2x23 kw/87Hz |
| Gearbox | Helical reducer |
| Safety device type | centrifugal brake |
| Power supply range | 380–500 V, 50 or 60 Hz, 3 phase |
| Type of mast | square column 650*650 mm with bolted rack |
| Length mast section | 1.508 m |
| Rack module | 8 |
| * Increased lifting height on request. 250 m with step-up
transformer only. 400 m with step-up/step-down transformer. |
