Freezer LJSGF01
LJSGF01 Freezer is used for short time refrigerating and heating
the spreading gun of
Sealant spreading machine, while you don’t need to wash and clear
the spreading gun.
The use of machine can reduce the waste of sealant for clean the
gun, reduce the
production cost, and greatly increase the work efficiency.
LJSGF01 Freezer is one of the accessory machines for Sealant
spreading machine to
produce Insulating Glass. It has the following features: cover
small floor area, easy to
move, reliability, easy service, and so on.
Freezing & Heating
The freezer have two parts:one for heating,another one for
freezing.
Machine's body
Heating and freezing switch, easy to operate.
The Freezer adopts the most advanced America Refrigerating system,
the core component
(scroll compressor) of which is with the features of high
efficiency, low noise, high reliability,
and so on. The operator can adjust the work parameter at any time,
and the temperature
status of cold and hot barrel is showed clear on the screen.
Structural Feature and Function
The LJLX01 Freezer is comprised of stander, refrigerating unit,
refrigerating barrel, heating
barrel, electric control system and so on.
The refrigerating of antifreeze is completed by the combination of
refrigerating unit and
refrigerating barrel.
There is a commercial so called refrigerant in the storage tank of
compressor unit, it is colorless
gas in normal temperature, but under the pressure of itself, it is
colorless liquid. The compressor
compresses the refrigerant with high pressure when it is in gas
status, then; it comes through the
condenser and releases heat by means of cooling fin, at last,
condensed to liquid status. Due to
the liquid refrigerant losses the pressure from condenser after it
passes through the capacity tube,
it becomes gaseous immediately when it comes through the evaporator
on the outside of refrigerating
barrel. As liquid will lower temperature when it becomes gaseous,
at the same time, absorbs the
latent heat from the anti-freeze in the barrel, thereby, low the
refrigerant’s temperature. Then, the
gaseous refrigerant in the evaporator will be forced back to
condenser by compressor and becomes
liquid. This cycle repeats again and again to take away the heat of
anti-freeze.
The refrigerant in the refrigerating barrel is the combination of
glycol and water, the mixing ratio is
1:1. After put the spreading gun in the barrel, the water level
should be 2 to 3 cm lower the bung.
The heating barrel is heated through outside ektexine by two
heaters, in order to increase the
temperature of inside water. The water level is the same as
refrigerating barrel’s.
The control part in panel consists of temperature controller and
switch. It adopts digital temperature
controller, which can switch on or off at any time and adjust the
temperature of cold and hot barrel.
Main feature
• It is used for storing the gun when manual glue gun stop work
during the process of gluing
insulating glass
• Storing at low temperature,to prevent sealant solidify
• Apply to polysulfide and silicone
• Can be effectively reduced waste when cleaning the glue
| Max refrigerating temperature | 70ºC |
| Min heating temperature | -40ºC |
| Total power | 3.8kw |
| Refrigerating | <150min |
| Overall dimension | 1550*60*1300mm |
Contact us
Jinan Lijiang Automation Equipment CO.,LTD
Add: Block B 1307,Green Square,Huaiyin District,Jianan,China
Tel: +86-531-85960498
Fax:+86-531-87562846
Http:en.lijiang-glass.com
E-mail:info@lijiang-glass.com
