Durable Automatic Systems Turnstiles Biometric With Led Direction
Indicator
Specifications:
| Dry contact: DC12V, 10mA | Two directions controlled/one direction controlled |
| RS485 interface | LED direction indicator |
| Pulse voltage signal, more than 100ms | Flow Speed: |
| Passageway: ≤700mm | 40 people/minute in the opening mode |
| Power: AC220V, 50Hz | 25-30 people/minute in the closing mode |
| Operating environment: -25 to 60 degree, RH ≤90% | Illegal invasion sound alarm |
| Dimensions: ￠168 x1050mm | Anti-strike function |
| Can connect various access controllers such as IC/ID reader/writer,
button controller, barcode controller, code controller, fingerprint
controller, or computer | Keep open status if the power supply fails |
Reader:
2.1. Frequency:13.56KHz
DIM:Length85.6mm × Width53.98mm × Thickness1.8mm
Material:Hard Shell = ABS；Cover Foil = PVC
Color:White , black, grey, blue, yellow
Power requirements: 5-16VDC at 100mA, A linear regulator is
recommended
Interface: Weigand
Reader range: 5 - 10 cm
Frequency: 122-128KHz
Operation temperature: -30 C to +60 C
operationg humidity: 5%-95% relative humidity non-condensing
Audio/Visual Indication: Green & Red and Buzzer signal output
Response Time: Less than 0.2 seconds
cable length: 250mm
Weight: 60g
2.2. Wiring :
Red: Power 5-16V
Black: Power ground
Green: Wiegand output D0
White: Wiegand output D1
Brown: Green LED control
Blue: Buzzer control
Yellow: Hold
LED/Buzzer function description:
LED function: The LED color is normally in RED. It starts with 2
green flashes on power up the reader and remains RED. When a RFID
proximity card is present to the reader, The LED will momentary
flash green,this indicates that the card was read properly by the
reader. When the LED control signal is active, the LED changes to
green.
Beeper Function: Power up the reader, the beeper will active 2
times. When a RFID proximity card is present to the reader, a short
beep will be emitter. This indicates that the card was read
properly by the reader. When the Buzzer control signal is active,
the buzzer will sound till buzzer control line is released
Hold function: when this line is asserted,(made low by HOST) the
reader will buffer one card read (ignoring subsequent reads) until
the line is released.(made high or open)
