The pebbles sand making process is divided into four stages: coarse
crushing, medium fine crushing, sand making and sieving.
The first stage: coarse crushing
The pebbles blasted from the mountain is fed uniformly by the
vibrating feeder through the silo and transported to the jaw
crusher for coarse crushing.
The second stage: medium broken
The coarsely crushed materials are screened by vibrating screen and
then conveyed by belt conveyor to cone crusher for medium crushing.
The crushed stones are conveyed to the vibrating screen through a
belt conveyor to sieve out different specifications of stones. The
stones that meet the requirements of the customer's particle size
are conveyed to the finished product pile through the belt
conveyor. The cone crusher crushes again, forming a closed circuit
cycle.
The third stage: sand making
The crushed material is larger than the size of the two-layer
screen, and the stone is conveyed to the sand maker machine through
the belt conveyor for fine crushing and shaping.
The fourth stage: screening
The finely crushed and reshaped materials are screened by circular
vibrating screen for coarse sand, medium sand and fine sand.
Note: For the sand powder with strict requirements, a sand washing
machine can be added behind the fine sand. The waste water
discharged from the sand washing machine can be recovered by the
fine sand recycling device. On the one hand, it can reduce
environmental pollution, and on the other hand, it can increase
sand production.
FEATURE INTRODUCTION OF RIVER PEBBLES SAND MAKING PLANT
The sand making production line has the features of reasonable
configuration, high automation, low operation cost, high crushing
rate, energy saving, environmental protection, high capacity and
easy maintenance, the manufactured sand conforms to national
standard for construction sand, uniform grain, excellent particle
size, well graded.
The equipments of the sand making production line are configured in
accordance with the specification and output as well as application
of the sand, we provide solution and technical support, and design
the process according to the production site of customer, we make
every effort to provide the most reasonable and economic production
line for customers.
Technical description:
1. This process is designed according to the parameters provided by
the customer. This flow chart is for reference only.
2. The actual construction should be adjusted according to the
terrain.
3. The mud content of the material cannot exceed 10%, and the mud
content will have an important impact on the output, equipment and
process.
4. SANME can provide technological process plans and technical
support according to the actual requirements of customers, and can
also design non-standard supporting components according to the
actual installation conditions of customers.
