Full Face Masks Flame Resistance Testing Equipment
Introduction
Fireman fire-protective clothing is mainly composed of jacket and
bib composition,may also wear fire protective helmets, fire
protective boots and fire-protective gloves!Each set must be fitted
a serial number of check marks with strong national fire equipment
quality inspection center is to be manufactured.
This flame resistance testing equipment is designed
andproductedaccording to EN 136 and GA 124-2013 latest version of
the standard development.It meets the standard tool for back, back
with a belt buckle, bottle protective cover and full face shield
barrier combustion performance test.
The fire resistance testing equipment is intelligent, touch-screen
control system; the freedom to choose different samples of test
procedures; and test results are automatically saved.
Standards:
• EN 136: Respiratory protective devices - Full face masks -
Requirements, testing, marking
• GA 124-2013 latest version of the standard requirements
Structure
1, Cabinet is painted, elegant appearance;
2, The full face mask and back strap with a combustion device with
platform integration of structural design;
3, All toolings are made of stainless steel, appearance, corrosion
resistance;
4, Pressure gauge and a pressure regulating valve;
5, Needle valve control the flow rate of the burner gas ;
6, PLC and touch screen control systems; test interface is easy to
operate;
7, The system automatically timing, the heat data is automatically
recorded and stored;
Full face mask test section
• Burning test private metal mould
1, Six imported burner nozzle, you can control propane and air flow
rate,
2, Burner nozzle height can be adjusted up and down; 250mm from the
outer surface of the specimen,
3, Pressure gauge and regulator valve regulates the burner gas
pressure in the range of 0 ~ 10kPa,
4, Gas automatic blocking device, which blocked gas supplies when
the test is 5seconds,
6, Automatic ignition, switches off automatically after 5s
ignition;
• Back with strap test section:
1, Stainless steel baffle plate, appearance and corrosion;
2, Imported Bunsen burner, gas and air flow rat
3, Torch lifting device; stainless steel sample holder;
4, Automatic timing;
5, Flame height is 40mm; the temperature at 20mm is 800 ± 50 ºC;
6,Aomatic ignition, turns off automatically after 20s ignition;
Basic information
| 1 | Power supply | AC 220V, 50 / 60Hz, 15A |
| 2 | Dimension | 1,400 (W) x 650 (D) x 1,300 (H) mm |
| 3 | Weight | 80KG |
