15KW - 44kW , HC42 - 3150 Scrap Metal Shear / Pressure Force 3150KN
Introduction
HC42 Gantry plate shear machine is suitable for steel mills, metal
recycling and processing industry and non-ferrous metal, ferrous
smelting industry, etc.Can be all kinds of steel and sheet metal,
scrap metal part to cold cut into required size, specification to
save transportation cost and improve the efficiency of smelting.
HC42 series square sheet shear machine adopts hydraulic
transmission, compared with the mechanical drive type shears, has
small volume, light weight, small inertia, low noise,stable
movement, convenient operation, flexible, large shear section,
scissors, not soft not hard mouth, when shear is not short of
blasting, long service life, no gap again thin all good shear,
convenient adjustment and operation safety. This machine has
manual, automatic, convenient operation, simple control, scissors
mouth work in any position in the process of starting cut and stop,
and can according to the size of the cut materials, arbitrary
control cut the size of the mouth, in order to obtain the best
working efficiency.The equipment design of fast, without any
increase in power of the motor and pump displacement condition, in
(about 400 tons) under the shear rate maintained rapid, large shear
materials automatically converting speed.Recover the original shear
force, so as to improve the work efficiency nearly doubled.
Technical Specificarions | Remark | Shear cylinder
| model | YG320/220-200 | Quantity | 1 |
| Nominal Force | 3150KN
| Stroke
| 200mm | press cylinder | model | YG80/50-150 | Quantity | 2 | Twin Parallel | Nominal Force | 125*2KN | Stroke
| 150mm | motor | model | Y220M-6 | Power | 18.5kw |
| Nominal speed
| 1470 R/MiN | Quantity | 2 sets | oil pump | Model | 80YCY14-1B | Nominal Pressure | 31.5 mpa |
| Nominal outputt
| 160 ml / r | Quantity | 1 set |
|
