Silica Sand Mining Conveyor Belt Z Type Design Easy Operation Avoid
Material Spilling
Advantages and Features
1. Low maintenance cost.
2. Large transport capacity, and it can avoid material spilling
effetely.
3. The belt can facilitate switching from horizontal to inclined
conveying and from inclined to horizontal conveying.
4. It saves a lot space as it allows material conveying at 0-90
degree.
5. The sidewall belt conveyor is widely used in coal, food,
building, chemical, water and electricity and metallurgy industry.
Application Scope
Easy Operation And Change Belt Z Type Belt Conveyor Machine For
Silica Sand is one of the most commonly used mining equipment, which is widely
used in mineral processing, construction materials, silicate and
chemical industries. In the production of small scale, medium scale
or large scale mineral processing Plants, it is generally used as
the transportation machine for metal ores of gold, silver, copper,
lead, zinc, nickel, manganese, iron, molybdenum , chromium, tin and
others, as well as stone, rock, granite, limestone, quartz,
graphite, feldspar, coal, etc.
Technical parameters for reference
Belt width (mm) | Cleat height (mm) | Handling capacity (m3/h) | Belt speed (m/s) | Inclination arrange (°) |
| 500 | 80 | 11-84 | 0.8-2.5 | 30-90 |
| 100 |
| 120 |
| 650 | 100 | 23-180 |
| 120 |
| 160 |
| 800 | 120 | 36-280 |
| 160 |
| 200 |
| 1000 | 160 | 45-500 |
| 200 |
| 240 |
| 1200 | 200 | 57-800 |
| 240 |
| 300 |
Working Principles
The horizontal loading section leads a deflection wheel bends the
belt into the feeding of the bulk material takes place on a mostly
horizontal feed path, where the side wall belt is supported by
loading impact idlers. The feeding of the conveyed material can be
achieved by direct feeding from a hopper, over a chute, a feeding
belt or a feeding pulley. The selection of the optimum feeding
station depends on the properties of the bulk material and the belt
speed of the vertical conveyor. The upward and downward strands are
encased from the bottom to the top. Substructures or support
rollers are not necessary in this section.
The vertical section leads over a deflection curve into the
horizontal discharge section. The deflection curve is made up of a
number of high specification pulleys. These pulleys experience the
vectored load of deflecting the belt tension from vertical to
horizontal.
At the drive pulley, the bulk material is discharged and the belt
is returned to the back going strand. Depending on the bulk
material properties, the drive pulley is followed by a beater wheel
for belt cleaning in the return side. The beater is self-driven.
Material that fails from the belt goes into the main delivery
chute. Lateral deflection wheels turn the belt from the horizontal
back to the vertical.
Operation regulation and maintenance
1.Belt conveyor should be operated in according to design
requirement.
2.Belt conveyors are not allowed to overload run.
3.Check wear condition of the belt, the damaged should be repaired.
4.Operators should circuit to inspect to close observe belt
conveyor running. Especially,temperature rise and noise of main
motor and the brake working whether they are normal; contact state
of the brake and oil level, noise of gear unit and run off of belt
should be noticed;temperature rise and noise of all bearings and
state of all transition loads point should be noticed;
