CE Certificate FFP1V Save Mask ,Valved Dust Mask , Non Woven
Fabric,Only For Single Use
1 . Descriptions
FFP1V Dust Mask with adjustable aluminum nose clip makes wearing
more seal less leakage .With latex-free elastic strap , soft nose
liner , softer and fit the face .Easy-breathing valve makes
breathing more smooth .
It can be used on Cutting and Casting of Metals,Disposal of Toxic
Waste,Hospital,Iron and Steel Industry,Laboratory and Disease
Control,Manufacture of Batteries and so on.
3-plys, PP spunbond outer layer,PP meltbrown high filteration
layer, PP spunbond inner layer.
2 . Mask CE Quality Standards
| CE Standard for Disposable Respirators |
| EN: 149:2001 + A1:2009 |
| Distinguish | Filter Efficiency | Penetration | Resistant |
| FFP1 NR | ≧80% | < 20% | < 21mmH2O |
| FFP2 NR | ≧94% | < 5% | < 24mmH2O |
| FFP3 NR | ≧99% | < 1% | < 30mmH2O |
1 . Stardard : EN : 149 : 2001 + A1 : 2009
2 . Test Machine : TSI 8130
3 . Test Flow : 95Liters/Min
4 . Test Medium : NACL & DOP
3 . Certification
This product has been tested according to the following European
Standard:
EN149: 2001 +A1: 2009. Respiratory protective devices. Filtering
half masks to protect against particles. Requirements, testing,
marking.
It complies with European Regulation (EU) 2016/425 on Personal
Protective Equipment (PPE).Category III.
EU type examination certificate (module B) issued by BSI , notified
body n°0086.The PPE is subject to the conformity assessment
procedure based on internal production control plus supervised
product checks at random intervals (Module C2) set out in Annex VII
under surveillance of BSI , notified body n°0086.
4 . Directions for use
- The mask is for single use only.
- The mask should not be removed from its packaging until its
required for use.
- Use the respirator in accordance with applicable health and safety
regulations.
- Fit the respirator and check leak-tightness before entering the
contaminated area.
- Wear the respirator for the whole duration of exposure to
contaminants.It should not be used for more than 8 hours
continuously and should be discarded after use.
- Transport and stockage of unused masks should be such that the
product is not stored in direct sunlight and in frost free
conditions,not in contact with solvents and cannot be damaged by
physical contact with hard surfaces/items.
- As required by European Health and Safety requirements,the user is
advised that when the mask is in contact with the wearer’s skin,it
may cause allergic reaction to susceptible individuals.If this is
the case,leave the hazard area,remove the mask and seek doctor’s
advice.
- If maintained as per storage instructions , product can be used up
to 5 years from date of manufacture.
5 . Packing
Normal Packing12pcs/box,240pcs/ctn
6 . Warning
- The user should be trained in the fitting and should be aware of
the instructions for using prior to donning the respirator.
- Use in adequately ventilated areas,which are not deficiency of
oxygen.
- Do not use this respirator when oxygen concentration is less than
19.5%.
- Do not use the mask in explosive environment.
- The mask must be fitted correctly to ensure the level of protection
expected is achieved.
- The facila hairs or heards and certain facial charactrtistics may
reduce the effectiveness of the mask.
- For mask mark marked “NR”,the particle filtering half mask shall
not be used for more than one shift.
7 . More pictures
