Hot Sale Exit Number Sign Traffic signs Guide Road Signs On High
Speed Way
Product introduction: The next exit notice sign When the
interstitial three-dimensional cross-spacing is greater than or
equal to 3 km and less than 5 km, an exit notice sign should be set
up to inform the next exit information and distance. Generally,
only one of the distance sign on the expressway and the next exit
notice sign is required.
Product introduction: The exit number mark is used to identify the
exit number. This sign is not set separately, it is usually set at
the top corner of the exit notice sign, and it is set at the upper
left or upper right corner according to the relative position of
the exit.
Product introduction: The exit notice sign is used to notice the
exit ahead. At the distance of 2km, 1km, 500m and the starting
point of the gradual section of the deceleration lane of the
expressway or urban expressway, 2km. 1km, 500m exit notice signs
and exit notice ( (Action point) signs, exit notice signs should
also be attached with exit number signs.
Hot Sale Exit Number Sign Traffic signs Guide Road Signs On High
Speed Way
Road signage characteristics
1.High intensity
The strength of the product is ten times that of plastic products,
and the strength is much more than that of aluminum, reaching the
level of ordinary steel.
2, acid and alkali resistance, corrosion resistance
Product corrosion resistance, can resist water, gasoline, alcohol,
electrolytic salt, acetic acid, hydrochloric acid, sodium and
potassium compounds, urine, asphalt, suitable for a variety of acid
and alkaline soils.
3, beautiful appearance
The product has good color adhesion, good gloss, beautiful
appearance, safety and environmental protection.
4, anti-aging
The product has strong weather resistance, resistance to thawing
and moisture, and a service life of more than 20 years.
5, good comprehensive economic benefits
The product is light in weight and easy to transport and install,
which can greatly reduce labor and reduce labor intensity.
Principles of setting traffic signs
1. The setting should be considered comprehensively, the layout
should be reasonable, and the phenomenon of insufficient
information or overload will be prevented. Information should be
connected and important information should be displayed repeatedly.
2. Generally, it should be set on the right side of the road
travelling direction or above the carriageway; it can also be set
on the left side, or on the left and right sides at the same time
according to specific conditions.
3, in order to ensure visibility, when more than two signs are
required at the same location, they can be installed on a support
structure support, but more than four should not be installed;
separate signs should meet the prohibition, instruction and warning
signs. Set space.
4, in principle, to avoid the juxtaposition of different types of
signs. If conditions cannot be set independently, there should be
more than two signs on one support structure. When a support
structure is supported and set up, the order of prohibition,
instruction, and warning should be arranged up and down, and then
left and right.
5, should not be set more. When more than two warning signs need to
be set at the same location, in principle only one of the more
needed ones should be set.
Reminder from Chongqing Jiuzhou Transportation Facilities Co., Ltd
.: We can make a variety of safety identification series products
on demand, with diversified products and multiple levels, which can
meet different scenarios and different needs.
For more information, please contact Whatsapp/WeChat/Tel:
17830584616
