Vertical or Horizontal Type Foam Bladder Tank , Fire Fighting
Suppression Foam Pressure Tank
INTRODUCTION
The foam bladder tank is the main unit of the foam extinguishing
system. The foam tank and the low/medium expansion foam generator
construct the low/medium foam spraying system. It can also
construct the high expansion total flooding extinguishing system
with high expansion foam generator. It aims at fire of class A and
class B, especially for fire of class B.
The foam bladder tank mainly applied in occasions such as places
where inflammable liquid was produced, stored and transported. It
is especially suitable to put out fire caused by inflammable liquid
tank or large scale of spill fire.This method allows the water/foam ratio to remain stable by
automatically adjusting to the variable flow rates and pressure
conditions that may occur during system operation.This feature
makes bladder tanks particularly suitable for multiple hazard
systems, sprinkler systems and any other system operating under
variable, non predictable, flow and pressure conditions.
PARAMETERS
| Working Pressure Range (MPa) | 0.6~1.2 (87~174 PSI) |
| Pressure Drop (MPa) | ≤0.2 |
| Test Pressure | Strength (MPa) | 1.5 |
| Sealing (MPa) | 1.32 |
| Tank Capacity (L) | 200~15000 (52~3963 Gallon) |
| Size of Proportioner (mm) | DN80~DN250 (3"~10") |
| Flow Capacity(L/S) | 4~360 (63~1513 GPM) |
| Mixing Ratio (L/S) | 3% OR 6% |
INSTALLATION
Device should be installed at places with shelter to avoid sun and
rain. Ambient temperature should be within 40°C and leave enough
space for operation. Device should be installed at concrete floor
and fastened with anchor nuts.Do the hydraulic test after
installing. Open the tank vent valve first then fill water into
bladder from concentrate draining pipe. Then close tank vent valve
when bladder is full of water. Pressurize the system and keeping
for 10 minutes when pressure gets test pressure, tank should have
no leakage. Close water inlet valve and open water drainage valve
and concentrate drainage valve to drain water away in tank and
bladder. (We will do this test when products leave the factory)
FAQ
1. Do you offer free sample for your clients?
Yes, we offer sample for most of the products.
2. What's the MOQ of your products?
Our MOQ is one (1) piece/set.
3. Are you manufacturer with your own factory?
Yes, we are the manufacturer for more than 20 years.
4. What's your payment terms?
We accept T/T, L/C, Western Union,etc.
5. How long is the delivery time?
Usually around 12 days after payment.
6. Do you have technical support?
Yes, we have a professional engineering team.
7. Can you accept OEM?
Yes, we do customized design for our clients.
