Driver fatigue monitor with signal output 45km/h start-up speed

Description

Fatigue plays a major factor in crashes in the UK, one study found that 1 in 6 crashes resulting in death or injury on major roads are fatigue related. It is reported that about 40% of professional drivers, especially HGV drivers report increased levels of sleepiness which can result in a disproportionately high number of fatigue related accidents.

Fatigue related accidents can occur when commercial drivers have a lack of stimulation. The most common roads where this is likely to happen are motorways and dual carriageways. Sleepiness reduces reaction time, alertness and concentration which severely affects the driver’s ability to process information quickly enough.

Some common warning signs of fatigue includes – increased difficulty concentrating, yawning and heavy eyelids. These are signs of micro sleep. This is when the driver nods off for between 2-30 seconds without realising.

I/O and RS232 output optional:

I/O output is only a high/low voltage output, you can get only the alarm signal,the connection is easy. The default setting is high resistance status under normal status, low voltage output when triggered.

RS232 output has alarm signal and picture output, thus you can get the driver's face picture in the center, it need to integrate to the GPS system via protocol.

Attention:

Non-authorized person, please do not open or repair the device.

Please do not operate the system when driving to avoid dangerous

Please handle carefully, do not drop or impact with hard objectives

Do not use chemicals or cleaning agents to clean the machine, it will damage the machine surfaces or rust the paint.

keep it away from water or moist place, device will be rusted or shortcut in those area.

Do not rip, bend or squeezed the wiring by heavy object, or it will be hot to fire.

Power input and output

1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle, and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in 12V car, and 60mA in 24V car, similar with leakage from the battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm

Leisure Auto Security Equipments Ltd, established in 2009, is a factory dedicate in car safety products, especially driver fatigue alarm system. the new products driver fatigue alarm is a fruit of our 8 years' research and development, it is different from any other kind of system on the market, it is the best way to monitor the driver's status.

It adopted the most advanced non-contact infrared camera to capture human eyelid and retina status,( in general, before entering drowsy driving status, human retina was less and less sensitive to the light outside), analyzes the driver’s fatigue status according to PERCLOS method, and give out voice alarm before the driver falling asleep.

It can also detect the driver’s distraction and give out voice reminders to prevent accidents, such as talking with back passengers, adjusting audio, or operating navigator, pick up thing from the ground and so on.