Driver fatigue monitor with signal output 45km/h start-up speed
Description
I/O and RS232 output optional:
Operator Condition Detection
Utilizing in-cab sensors and detection equipment, LS-803 is a
non-intrusive fatigue and distraction solution that continuously
monitors operators to proactively prevent accidents. LS-803
infrared camera continuously monitors the operator for eyelid
closure, facial and head movements, and other unsafe behavior (cell
phone use, reading, etc.) while the vehicle is in motion.
I/O output is only a high/low voltage output, you can get only the
alarm signal,the connection is easy. The default setting is high
resistance status under normal status, low voltage output when
triggered.
RS232 output has alarm signal and picture output, thus you can get
the driver's face picture in the center, it need to integrate to
the GPS system via protocol.
Power input and output
| Input | 9-36V |
| power consumption | 100mA in 12V car, and 60mA in 24V car |
| I/O output | high resistance status under normal status, low voltage output when
triggered |
| Working Temprature: | 0-80℃ |
| Working Humility: | 10%-90% |
| Weigh: | 108g |
| Demension: | 4.5*10.2cm |
1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle,
and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in
12V car, and 60mA in 24V car, similar with leakage from the
battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low
voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm
