Taper 04 Endo Rotary Files , G3 ISO Green Reciprocating Files In
Endodontics
Simple use Endodontic Rotary File Eli Files Gold Working File G3
For Root Canal Treatment ISO Green
| Taper | Starter | 1.2 |
| P1 | .02 |
| P2 | .02 |
| G1 | .04 |
| G2 | .06 |
| G3 | .04 |
| Torque | Starter | 3.0 N/CM |
| P1 | 2.0 N/CM |
| P2 | 2.0 N/CM |
| G1 | 2.0 N/CM |
| G2 | 2.0 N/CM |
| G3 | 2.0 N/CM |
| Rotary Speed Range | Starter | 350 RMP |
| P1 | 300 RMP |
| P2 | 300 RMP |
| G1 | 300 RMP |
| G2 | 300 RMP |
| G3 | 300 RMP |
| Size | Starter | #120 |
| P1 | #16 |
| P2 | #19 |
| G1 | #20 |
| G2 | #25 |
| G3 | #35 |
| ISO Color | Starter | Yellow |
| P1 | White |
| P2 | Yellow |
| G1 | Yellow |
| G2 | Red |
| G3 | Green |
| Using Times | Generally difficult root canals | 10-15 times |
| Moderately difficult root canals | 8-10 times |
| Difficult root canals | 1-2 times |
| Cross Section | Triangle |
Operation Method
To adjust rotary speed and torque, turn on motor and use MG3 files
to achieve the working length, then replace files in order after
2-3 times up-and-down pulling.
Remark:Most of the root canals are usually completed preparing with
G2. But if non-enough preparation after G2, be continued with G3.
Description:
For simple root canal:
Operation Sequence:
1. 1. Use 10 # or 15 # stainless steel hand use files to search and
check root canals；
2. Use starter file to open the crown and upper-middle of the root
canal；
3. Use 10 # or 15 # stainless steel hand use K files to search and
check root canals until the WL；
4. Use G1,G2 to search until the WL；
5. Use G3 to repeat cutting until the WL for curved root canal；
6. Using sodium hypochlorite solution for fully flush when every
file preparation is finished and use 10# or 15# K file to cut until
the WL.
For complex root canal:
Operation Sequence :
Use K file (stainless steel) to search, prepare to extend the
upper-middle
of root canal according to personal habits, or use #10 or #15 files
in order to
operate.
2. Use starter file to prepare the upper-middle of root canal and
build a
straight path to reach at middle-lower of root canal;
Use 10# or 15# stainless steel K file to search the middle-lower of
root
canal to confirm the working length, then use P1(02/16#),P2(02/19#)
to smooth the root canal until the working length
3. Use the series of G files Successively to prepare the root canal
to the
working length:G1(04/20#),G2(06/25#),G3(04/35#)
