This device is a high performance underground metallic pipe
locating system.It consists a transmitter and a receiver, can be
used to do route tracing, pipe exploration and depth measurement of
the underground cables and metallic pipes.It can also be used to
identify target cable from a bunch of cables,locate the pipe
insulation damage and part type cable fault.
FUNCTIONS
l Compass display: to display pipe position directly.
l Real-time depth measure and current measure.
l History curve display: to display the signal variation directly.
l Cable Identification: Clamp (optional) identification and sensor
identification.
l Grounding fault location: Use A frame (optional) to pinpoint pipe
insulation damaged points against ground.
l Digitization high accuracy sampling and processing,narrow receiving
pass band to rise the anti-interference capability and suppress
power interference and harmonic interference from nearby running
cable and pipe.
l Multiple locating frequency: active detection and passive
detection.
l Multiple signal output mode: Direct connection output, Clamp
Coupling input, Radiation output.
l Big capacity Li-on batteries series,support auto power off when low
battery or long time no operation
l Solid case and light weight easy to carry
SPECIFICATION
Transmitter:
l Output: Direct Connection output, Clamp Coupling Output
(optional), Radiation output.
l Output Frequency: 640Hz (complex frequency), 1280Hz (complex
frequency), 10kHz, 33kHz, 83kHz.
l Output power: max. 10W, 10 levels adjustable, auto impedance
matching.
l Direct connection voltage: max. 150Vpp.
l Overload and short circuit protection.
l HMI: 128X64 LCD.
l Power supply: 4 X built-in 18650 Li-on batteries, standard 7.4V,
6.8Ah.
Receiver:
l Input: Internal receiving loop, Clamp (optional), sensor
(optional),fault locating A Frame (optional).
l Receiving frequency:
- Active frequency: 640Hz,1280Hz,10kHz,33kHz,83kHz
- Power frequency: 50Hz/60Hz,250Hz/300Hz
- Radiation frequency passive frequency: center frequency 10kHz,
33kHz, 83kHz
l Pipe detection mode: wide peak method,narrow peak method,valley
method
l Cable identification mode: Receiving Clamp (optional) intelligent
identification / sensor (optional) identification
l HMI: 320X240 LCD
l Built-in battery: 2 X 18650 Li-on batteries, standard 7.4V,3.4Ah
Other:
l Volume: transmitter 270x220x85mm,receiver 700x270x120mm
l Weight: transmitter 2.2kgs, receiver 2.2kgs
l Charger: input AC 100~240V,50/60Hz,output DC8.4V,2A
l Temperature: -10-40℃,humidity 5-90%,elevation <4500m
