High Flow Rate 4 Inch Diaphragm WPS-CA/EP102 for Solenoid Pulse
Valve Application Dedusting
Electromagnetic pulse valve diaphragm makes the whole dust
collector failure: because a valve diaphragm rupture, will lead to
a large reduction in the pressure of the whole air bag and
insufficient air volume, make the other valve on the air bag can
not normally spray. The dust removal of the dust remover is not
good, will produce local paste bag phenomenon, the dust remover air
cloth ratio increases, the operation resistance increases, speeds
up the shortening filter material working life.
The electromagnetic pulse valve diaphragm produced by the company
is imported and improved by the international advanced design
technology, which is used for the compressed air switch dust
removal of the dust collector dust removal system.
| Name | WATSON Pulse Valve Diaphragm |
| Model | WPS-CA/EP102 |
| Material | Nitrile Rubber |
| Hole number for mounting | 8 |
| Working temperature | depands rubber materials |
| Working pressure | 0.2Mpa-0.6Mpa |
| Working medium | Water, Clean Air |
| Diaphragm working life | More than 1 million cycles |
The other 4 Inch Big Diaphragms are also can be available
Are there air holes on the side and in the middle of the pulse
valve diaphragm?
Select pulse valve diaphragm can not simply look at membrane pores
in what position, but also look to and supporting the use of pulse
valve diaphragm in porosity in what position, if the pulse valve in
stomata in the edge edge will use in porosity of the diaphragm to
match, if there is no loophole edge of pulse valve should be used
with porosity of diaphragm, if you don't corresponding pulse valve
and the membrane pores, can cause air flow is not smooth, pulse
valve can't work normally, be sure to check carefully!
Failure and repair
1, spring damage, pulse valve spring on the spool is easy to
damage, the appearance of the pulse valve is a long-term blow to
the nozzle, the treatment is to replace the spring.
2, rubber mat damage, after a long time of use, the rubber pad on
the pulse valve spool is easy to damage, the appearance is that the
pulse valve for a long time to blow air into the nozzle, the
treatment is to replace the rubber pad.
3, valve core dirt, because the air intake is not clean, cause the
dirt accumulation at the valve core, the appearance is the nozzle
long air intake or power pulse valve does not work, the treatment
is to clean the valve core.
4. The diaphragm is damaged. After long-term operation, the
diaphragm is prone to fatigue and oxidation.
5. The throttle hole is blocked or damaged, and the inlet air is
not clean, which will easily lead to the throttle hole blocking.
The appearance is that the pulse valve has been blowing air to the
nozzle for a long time, and the treatment is to clean the throttle
hole. The damage or loss of the throttle orifice makes the throttle
orifice lose its interception function, resulting in abnormal
pressure relief. The appearance is that the pulse valve ACTS after
receiving electricity, and the pressure relief orifice releases
air, but the pulse valve does not spray, and the treatment mode is
to replace the throttle orifice.
Hope to receive your inquiry,waiting for at anytime
