135 T/H High Pressure Coal Fired CFB Boiler Header custom printed
hats
Coal Fired CFB Boiler Header Performance advantage
1. The key to the manufacture of the header is the welding of the
end cap (or head). When welding, most manufacturers use manual arc
welding, because the weld is single-sided welding, the root quality
is difficult to guarantee, and because of the huge of welding work,
number of repairing times, the production cycle is long which cause
the entire production process slow.
2. Our company adopt the advanced production technology,
well-equipped instrument and sophisticated technology, and invented
a submerged arc welding method during the header and cover welding.
The character is: In the submerged arc welding machine head
threading mechanism fixed connection welding wire guide, along the
wire guide head to set the wire guide hole, the wire lead head has
a certain degree of curvature, welding the inner wall, the wire
guide head extension Into the inside of the welding.
3. The welding method mainly solves the problem that the existing
welding method of the boiler header and the end cap (or the head)
has the advantages of low processing efficiency, waste of argon at
the time of processing, need to open the groove, have many
processes, high processing cost and unsatisfactory welding
fabrication.
Features
1.Headers form an important part of all types of boilers. Steam
from the generating tubes is collected in headers which are
therefore always under pressure. This pressure may vary from 300
psi to 2000 psi.
2. Since headers are always under pressure, the utmost care is
taken by us while fabricating them. Depending on the generating
capacity of the boiler the header sizes fabricated by us vary from
100 mm to 600 mm NB. The stubs of various sizes are very carefully
welded to the main body of the header to provide the desired
openings from the headers
3. Bevelling and weld preparation of stubs duly tack-welded to the
main body of the header are first shown to Chief Inspector of
Boilers for his approval and once again the stubs fully welded with
main body are shown to Chief Inspector of Boilers under hydraulic
pressure, varying from 1000 to 3000 psi as required by the
specifications.
4. The headers are stamped by Chief Inspector of Boilers before
they leave our manufacturing plant. We also weld skubolets and
weldolets in place of stubs.
Details
1. The pressures and temperatures that headers have to withstand
depend on the component to which they are connected. A header
connected to an economizer or to water wall panels is subject to
less severe requirements on the material than a header connected to
superheaters or reheaters.
2. Depending on the temperature and pressure of headers, Vallourec
supplies tubes in carbon steel to high-alloy ferritic steels such
as T/P91 or T/P92, with sizes ranging from 88.9 mm to 406.4 mm.
Specification
| Material | Carbon steel,Alloy steel,Stainless steel. |
| Length | According to costumes requirements. |
| Temperature Range | 300℃~1500℃ |
| Diameter(OD) | 76mm~914mm |
After drilling
