Energy Saving Transformer Automatic Roll Forming Machine For Oil
Immersed Distribution Transformer
Transformer Automatic Roll Forming Machine Introduction
1. The unwinding machine includes three parts: hydraulic device,
mechanical mechanism and automatic unwinding. It is an
indispensable equipment for feeding with corrugated sheet forming
machine.
2. Working principle: The upper and lower parts of the SPCC coiled
steel material are realized by the hydraulic device. The inner
diameter of the hole is less than 500mm, and the inner diameter of
the general coil steel is 500mm. After being placed in the
position, the hydraulic tensioning device is used to ensure that
the coil does not move. After the position is fixed, the inside of
the corrugated sheet forming machine is manually unwound, and the
feeding is completed. In the working process, the photoelectric
switch is used to control the retracting of the coil material, and
the feeding speed of the corrugated sheet forming machine is at the
same frequency.
Technical Parameters
1) The internal diameter of the coil: minimum 470mm, maximum 520mm
2) Maximum outer diameter of steel coil: 1100mm
3) Coil width: ≤ 1300mm
4) Coil weight: up to 5 (including inclined support structure)
