Constructions Hollow Cross Section Plate Die 1200 - 2200 Mm Width 1
Year Warranty
Descriptions :
PC hollow plate used widely in constructions and decorations. The
hollow grid plate die and feedblock can make UV protection on both
sides. The final production with a max width of 2100mm and have a
high impact strength, good weather resistance and UV protection.
With adjustable upper and lower mold lips, production thickness
relative errors can be controlled within 3%.
Different design can meet the different requirements of products,
general polycarbonate hollow plate whose thickness is between
4-25mm, multi-layer plate such as H-cross section, X-cross section
etc. the thickness of some can reach 36mm and the UV layer can be
coated.
The PP, PE hollow grid plate produced by special dies are light
weighted, dampproof and have a high impact strength, which is
widely used as advertising light panel, exhibition upholster, carry
box etc. Thickness range is 2-12mm and the width is 1200-2200mm.
- Extrusion Die Repair Upgraded
We will provide you a whole set standard service with general
maintenance, die clean, examination, repair, upgrade, renovate and
so on. After renovates the die, it can achieve or very close to the
initial standard.
Every need to repair the die we will strictly according to the
following steps :
Die remove, cleaning.
Inspection, evaluation and communicate with customer requirements
for renovation.
Faded except the original chromium plating.
Repair damaged surface defects or change the defects in design.
Replace damaged parts.
Repairing mold body joints.
The mold flow channel to polish.
Reassemble the die.
Proofreading technical specification.
