DC/AC 4V320-08 1/4'' Solenoid Valve For Double Acting Pneumatic
Cylinder
4V pneumatic solenoid valve has five threaded holes, three on one
side and two on the other. The larger one in the middle of the
three holes is the air intake hole, and the air inlet hole is
connected to the triple piece (note that the triple piece is
directional). The two holes are vent holes, and the vent hole only
needs to be equipped with a muffler. can. The other two holes on
the other side are the working holes, which are the two holes on
the front and rear end caps of the cylinder, so that they are
basically assembled. Maintain the continuous airflow, and adjust
the pressure of 4-5MPA through the pressure regulating valve to
control the piston of the cylinder to reciprocate by energizing and
de-energizing the solenoid valve.
Technical data chart of DC/AC 4V320-08 1/4'' pneumatic solenoid
valve:
| Model numbers | 4V310-10 | 4V320-10 | 4V330C-10 | 4V330E-10 | 4V330P-10 |
| Position numbers | Two position five way | Three position five way |
| Operating medium | 40 Mircon litered air |
| Working type | Internally pilot operated |
| Wiring Forms | Lead wire or connector type |
| Packing dimension | 13.52x2.7x4cm | 19.04x2.7x4cm | 20.94x2.7x4 cm |
| Highest action frequency | 300 cycles per minute |
Valve body pictures of 4V320-08 5 port 2 position pneumatic air
solenoid valve:
Inlet,Outlet & Vent Pictures of 4V320-08 double acting pneumatic
solenoid valve:
Production Environment of 4V320-08 electro pneumatic solenoid
directional control valve:
Double-acting cylinder with 4V double coils pneumatic solneoid
valves:
The double-acting cylinder is a solenoid valve that requires a
two-position five-way. A pneumatic connector, PU tube is required
to connect these components. Which type of fiber is selected
depends on the screw hole on the cylinder or solenoid valve.
Two-position five-way solenoid valves are usually used with
double-acting pneumatic actuators. Two positions are controllable:
on-off, five-way is five-channel ventilation, one of which is
connected to the air supply, two and two The inlet and outlet ports
of the external air chamber of the cylinder are connected, and the
two are connected with the inlet and outlet ports of the internal
air chamber. The specific working principle can refer to the
working principle of the double-acting pneumatic actuator.
In the gas path (or liquid path), the two-position three-way
solenoid valve has one intake hole (connected to the intake air
source), one air outlet (provided to the target equipment air
source), and one exhaust hole ( Generally, a muffler is installed,
and if it is not afraid of noise, it can be installed. The
two-position five-way solenoid valve has one intake hole (connected
to the intake air source), one positive action air outlet and one
reverse action air outlet (one positive and one reverse action air
supply respectively for the target device), 1 A positive action
vent and a reverse vent (with a muffler installed).
Welcome to your inquiry!
