Desk Top Fiber Optic Equipment Fiber Fault Detector For Patch Cord
Testing
Product Description:
Table four channel red light source using 650nm laser as the light
emitting device, the output power can reach 10mW; at the same time
support four path fault detection..This product has the advantages
of simple operation, can be used to do a visual test of optical
fiber, optical cable, connector, when the measured fiber has a
breakpoint, laser propagating along the fiber will leak at the
breakpoint, which can determine the fiber breakpoint location.This
method can be used in both single mode and multimode optical
fibers. This series of products can be used for active devices and
passive device test, single channel and multi-channel optical
testing at the same time, especially for the multiplexed testing
required for the mass production of optical devices.
Product features:
l Constant power output, stable performance, long life
l High output light power
l Single or multichannel simultaneous detection can be realized;
four channels are supported at the same time
l Easy recognition of optical fiber breakpoints and bending
l The realization of the detection of the mechanical continuity
point
l Adopt an AC adapter
Application areas:
- Light device production
- Telecom Engineering Construction and maintenance
- Construction and maintenance of CATV Engineering
- Construction and maintenance of integrated wiring system
- Teaching and testing of light communicatio
- Laboratory test
Technical parameters:
|
| Working wavelength | 650±10nm |
| Number of channels | 4 |
| Maximum output light power | 10 mw |
| Power waste | 5 W |
| working voltage | DC:7-15V |
| working temperature | -10°～ +45° |
| Storage temperature | -40°～ 70° |
| Connector type | FC/PC |
| size | 200*170*90(mm) |
Matters needing attention:
l Please carry out the safe operation according to the instructions
of the equipment.
l Please check whether the ground wire and fire line and the zero
line are installed correctly before the equipment is electrified.
l Please be careful to keep the head clean, so as not to reduce the
output light power.
