Submerged Aluminum Pneumatic Pulse Valve 1 inch Air Clean DMF-Y-25
High purity aluminum alloy die-cast valve body, using the top
butene rubber diaphragm, so that the diaphragm has a very high
tensile strength, aging resistance and low wear, so that the
electromagnetic pulse valve injection life is more than 1 million
times or three to five years of use without damage
Electromagnetic pulse valve is higher than the national standard
level insulation coil used by the protection grade reaches IP65
whole potting, full of copper enameled wire, coil number higher
than the national standard, to ensure the electromagnetic pulse
valve electricity and no damage to 6 million times, the
electromagnetic coil can rotate 360 ° in the pulse valve core,
junction box can be installed in a 4 x 90 ° rotation, can prevent
the exposed to rain water into the open, greatly convenient to
install a different point of view.
Working Pressure:0.1~0.8MPa
Working medium:Air
Voltage:DC24V,AC110V,AC220V
Current:1A,0.46A,0.23A
Working Temperature:-25~80℃
Relative humidity:≤85%
Weight:0.75Kg
Material Construction:
| Body | ADC12 die cast |
| Armature | 430FR stainless steel |
| Diaphragm | Nitrile or viton |
| Spring | 321 Stainless steel |
| Fasteners | 302 Stainless steel |
Dimensional drawing:
The electromagnetic pulse valve is the "switch" of compressed air
in the dust removal and injection system of the pulse bag filter.
Controlled by the output signal of the pulse jet control
instrument, the filter bag is sprayed to clear the dust one by one
row to keep the resistance of the dust collector within the set
range to ensure the processing capacity and dust collection
efficiency of the dust collector.
Dmf-y-type electromagnetic pulse valve is a submerged valve, which
is directly installed on the air bag and has better circulation
characteristics. Pressure loss decreased, suitable for low pressure
air source working conditions:
1.Electromagnetic pulse valve (also known as diaphragm valve) is
the "switch" of compressed air in the dust removal and injection
system of pulse bag filter.
Controlled by the output signal of the pulse jet control
instrument, the filter bag is sprayed and cleaned one by one
(chamber) to keep the resistance of the dust collector within the
set range, so as to ensure the processing capacity and dust
collection efficiency of the dust collector.
2.Working principle the electromagnetic pulse valve is in
accordance with electrical signals to control the opening and
closing of the valve body unloading hole, the valve body unloading,
the pressure in the back chamber of the valve gas emissions, the
pressure in the front chamber of the valve by the diaphragm
pressure hole throttle, diaphragm is lifted, the pulse valve for
injection
When the valve body stops unloading, the pressure gas quickly fills
the back chamber of the valve through the damping hole. Due to the
difference in the stressed area between the two sides of the
diaphragm on the valve body, the force of the gas in the back
chamber of the valve is large, the diaphragm can reliably close the
nozzle of the shutoff valve, and the pulse valve stops spraying.
