New Made in Japan Industrial Yaskawa Servo Drive Output 3 Phase
SJDE-02APA
DESCRIPTION
- Industrial Servo Drive
- ServoPack
- Servo Controller
SEPCIFICATIONS
Input Main Voltage: 200-230V
Input CONT Voltage: 200-230V
Input Mian PH: 1
Input Mian Frequency:50/60HZ
Input Mian Current : 8.9A
Input CONT Current : 0.25A
Output Power :750W
Output Voltage: 0-230V
Output Current: 3.7A
Output Frequency:0-300Hz
Output PH :3
Temperture: 0-55℃
Place of Origin:Japan
Efficiency:IE 1
SIMILAR PRODUCTS
SJDE-01APA
SJDE-02APA
SJDE-04APA
SJDE-04APA+SJME-04AMB41
SJDE-08APA
SJME-01AMA41
SJME-04AMA41
SJME-04AWA41
SJME-08AWA41
Manual Alignment
• Connect the servo to the OctoIII
• Connect the Remote Alignment board with the flat cable.
• Put the Run/Align jumper on the OctoIII to the Run position.
• Put on the Center jumper
• Mount the servo such that the points are midway between the stock
rails
• Remove the Center jumper
• Put on the Mtry jumper
• On the Remote Alignment board:
• Use Next to set the the same number as the servo on the remote.
• Set the servo to Close or Thrown with Cls/Thr as desired (if the
servo does not move check that the Mtry jumper is on). Thrown is
indicated by a slow flashing of the LEDs.
• Press Cls/Thr for ~ 1 sec. The LEDs will start flashing rapidly.
• Press <--- and ---> repeatedly until the correct position
is achieved.
•Pressing <--- and ---> at the same time will recenter the
servo. • Press Next briefly to save the position.
• Repeat for the second position of the servo after changing the
servo position with Cls/Thr.
Speed - With the servo you want to adjust selected Hold the Speed
(right) button. Press <- or -> to raise/lower the speed. The
servo will move to show the new speed after each press. The left
button saves the new speed. Servo On/OFF - By default, the servos
stay on all the time. Sometimes you might wish to have the servo
turn off between movements to prevent it from drawing power. To do
this use the remote aligner. With the servo to be changed selected,
hold the Speed (right) button and press the Next button briefly).
The LED will flash twice quickly to indicate the turnout will turn
off between movments. (Note the LED will blink on/off slowly to
indicate the servo is in the thrown position - the lock is 2 brief
flashed followed by a long pause and quite distinct).
OTHER SUPERIOR PRODUCTS
| Yasakawa Motor, Driver SG- | Mitsubishi Motor HC-,HA- |
| Westinghouse Modules 1C-,5X- | Emerson VE-,KJ- |
| Honeywell TC-,TK- | GE Modules IC - |
| Fanuc motor A0- | Yokogawa transmitter EJA- |
