When installing the machine, it is necessary to confirm the various
environmental conditions. If the conditions are not met, erroneous
actions may occur, damage the machine and reduce the service life
of the machine.
Temperature: 0 ~ 40 C (ambient temperature during operation);
Humidity: 75% below (relative humidity), no condensation.
Altitude: below 1000 meters above sea level.
When the humidity is too high, the insulation condition will be
poor, the parts will aging ahead of time, do not install the
machine in the humid environment. Also do not install in dusty
places or places with high concentration of organic gas and
corrosive gas. Keep away from machinery such as welding machines
which may cause electrical interference or have magnetic field.
Ground load analysis should be carried out by civil engineering
experts. If the machine is installed on the reinforced concrete
floor, the preparation of foundation before installation is
generally not needed. If the machine is installed on the ordinary
workshop floor, the corresponding foundation must be prepared. Pay
attention to the machine installation must be based on the
foundation map.
1). Parallelism between templates
Usually, the parallelism between fixed template and mobile template
datum is up to standard, but due to improper transportation and
installation, it may change, and it should be re-checked after
installation. If the value exceeds the specified value.
Tolerance requirements for parallelism between fixed and mobile
template mounting surfaces are shown in Table 9-2.
Table 9-2 Parallelism Tolerances
When the closing force of effective spacing of tie rod is zero, the
closing force is maximum.
Over 200-2500.200.10
>250-400 0.240.12
>400-630.320.16
>630-10000.400.20
>1000-1600.480.24
>1600-2500.640.32
