Eco - Friendly Steel Lattice Transmission Tower 11m 500dan Steel
Tubular Pole IP65
Specifications:
1. Protecion class: IP65
2. Light source: 100W-400W high-pressure sodium lamp
3. Rated voltage and frequency: 220V(±10%)/50Hz
4. Caliber: 60mm
5. Protecting class against eletric shock: Type I
6. Lamp in die-cast aluminum, coated with powder polyes ter after
anti-corrosive treatment
7. A lamp body with a built-ray lens
8. Fasteners screws, all stainless steel
9. Applicable height: 6m-12m (according to customers' requirment)
10. Working environment:-35°C--+55°C
11. Long term life :more than 100,000 hours
12. Nast of steel, coated with powder polyester after hot
galvanizing treatment
13. Lamp can adjust up,down or around and can be changed the
projection angle
14. Environmentally friendly:instead of liquid mercury, easy to
recycle
15. Applicable places: City Road,overpass,factory
areas,bridge,harbour and etc.
Minimum yield strength | 355 mpa |
Minimum ultimate tensile strength | 490 mpa |
Max ultimate tensile strength | 620 mpa |
Maintenance
The hot dip galvanization treatment can increase the service life
of the steel pole without the environmental
pollution and no need for other daily maintenance. The following
described types are specially designed for Africa
Market which can meet the regulated height and load standard of
France electricity power company.
Production
Our steel pole is bent to form to the polygonal (conical) section
firstly. Then it is welded by the automatic
submerged-arc. Then it is welded by the automatic submerged-arc
welding machine.
Thirdly the top cap, strip and base plate will be welded to the
pole. And finally other accessories (support brackets,
ladder support, etc.) will be welded to the pole shaft.
Manufacturer Tolerance
- Component Length: -25mm to 75mm
- Straightness: 2mm/m
- Twisting degree: 1̊ per 3 meters length
- Ovalisation : Maximum is 3%
- The average diameter : +/-0.5%
-Slip length: +/-150mm
Mechanical Property
The metal supports are designed to withstand the nominal force F
and the pressure of the wind V applied at
0.25m from the top. Under these loads, the safety factor with
respect to the elastic limit of the steel is larger than
1.8. The post also resists a torque equal to (F+V) ×1m. Tests shows
the load intervened when breaking is around
2 times of design load.
