Siemens 6ES7288-2DR32-0AA0 S7-200 SMART, Digitale E/A SM DT16, 8DI/8DO, 8 DI DC 24V, Sink/Source, 8 DO, Transistor 0.75A

Siemens 6ES7288-2DR32-0AA0

SIMATIC S7-200 SMART, Digitale E/A SM DT16, 8DI/8DO, 8 DI DC 24V, Sink/Source, 8 DO, Transistor 0.75A
Input Current
From the backplane bus DC 5 V, typ. 115 mA; 5 V DC from the CPU module
The output voltage
Measuring the supply voltage of the inverter
● Rated value (DC) 24 V
● short-circuit proof No
digital input
Number of digital inputs 8
● in components 2
Parallel switch at the input Yes
Input characteristics according to IEC 61131, type 1 yes
Number of simultaneous controllable inputs
Horizontal installation position
— up to 50 °C, max 8
vertical installation position
— up to 40 °C, max 8
Input voltage
● Input voltage type DC
● Rated value (DC) 24 V
● For signal "0" < 5 V DC
● For signal "1" +15 to +30V
Input Current
● For signal "0", maximum value (permissible closed-circuit current) 1 mA
● For signal "1", the minimum value is 2.5 mA
● For signal "1", the maximum value is 5 mA
● For signal "1", typ. 4 mA
For unclosed contacts
— for signal "0", maximum (permissible closed-circuit current) 10 µA
Input delay (when input voltage is rated value)
for standard input
— When going from "0" to "1", the maximum value is 200 µs
— when going from "1" to "0", the maximum value is 200 µs
wire length
● Shielded, max. 500 m
● Unshielded, max 300 m
digital output
Number of digital outputs 8
● in components 2
M switch no
P switch yes
Short circuit protection no
On-off capability of the output
● Maximum value 0.75 A with resistive load
● Maximum 5 W at lighting load
The output voltage
● Rated value (DC) 24 V
● for a maximum value of 0.1 V for signal "0"
● For signal "1", min. 20 V
● For signal "1", the maximum value is 28.8 V; the maximum value is related to the input source L+ *
Output current
● Rated value for signal "1" 0.75 A
Output delay with resistive load
● From "0" to "1", maximum 50 µs
● From "1" to "0", maximum 200 µs
The two outputs are connected in parallel
● for logical connection yes; only outputs of the same group
● For increasing power yes; possible (only outputs in the same group)
● For redundant control loads Yes; only outputs in the same group
Total current at the outputs (per group)
All installation locations
— up to 40 °C, max. 3 A
Horizontal installation position
— up to 50 °C, max. 3 A
vertical installation position
— up to 40 °C, max. 3 A
All other installation locations
— up to 40 °C, max. 3 A
Alarm/Diagnostic/Status Information
Diagnostic Display LEDs
● for input status yes
● for output status yes
Galvanic isolation
Galvanic isolation of digital inputs
● between channels yes; optocoupler
Potential isolation of digital outputs
● between channels yes; optocoupler
insulation
Insulation test with 500V AC for 1 minute
EMV
Ability to resist static discharge interference
● Immunity to static discharge per IEC 61000-4-2 Yes; ±4 kV contact discharge (according to IEC 801-2/IEC 1000-4-2; ESD); ±8 kV air discharge (according to IEC 801-2/ IEC 1000-4-2; ESD)
— Test voltage during air discharge 8 kV
— Test voltage at contact discharge 4 kV
Anti-interference ability against high frequency electromagnetic fields
● Immunity to high frequency radiation according to IEC 61000-4-3 yes
— High frequency radiation in the frequency range 80 to 1000 MHz, 10 V/m, 1.4 to 2.0 GHz, 3 V/m, 2.0 to 2.7 GHz, 1 V/m (87 MHz to 187 MHz, 174 MHz to 230 MHz and 470 MHz In the range of MHz to 790 MHz: 3V/m)
Wire-related immunity to interference
● Interference immunity of mains conductors according to IEC 61000-4-4 Yes; 2 kV according to IEC 61000-4-4, impulse
● Interference immunity of signal conductors according to IEC 61000-4-4 Yes; ±2 kV according to IEC 61000-4-4, impulse
Anti-interference ability of pin shock voltage (surge)
● Mains lead according to IEC 61000-4-5 Yes; with pre-protective element
● Asymmetric coupling
— Test voltage 2 kV on supply conductors
- Test voltage 2 kV on signal conductors (greater than 30 m)
Interference immunity against the amount of wire interference caused by high-frequency fields
● Interference immunity for high-frequency feeds according to IEC 61000-4-6 yes
● Immunity to high-frequency radiation according to IEC 61000-4-6 Yes; 10 V/m with 80 % amplitude modulation 1 kHz
— Test voltage 10 V at 80% 1KHz amplitude modulation in the range 9 kHz ... 80 MHz
Suppression of radio interference emissions according to EN 55 011
● Radio radiated interference Emitted interference according to EN 50081-2, tested according to EN 55011, class A, group 1
● Limit value class A for applications in the industrial sector yes
Protection class and protection category
Degree of protection according to EN 60529
● IP20 yes
size
width 45 mm
Height 100mm
Depth 81 mm
weight
Weight, about 179.7 g

The company is a professional provider of integrated circuit chip spot is given priority to, professional agent distribution of ADI, ON, CYPRESS, INFINEON, MAX, TI, ADI, BROADCOM (BROADCOM) ST, , Microchip, XILINX, all series of products such as the world famous manufacturers of integrated circuits. Company's long-term with a large number of spot, products used in: aerospace, communication equipment, industrial control, medical equipment, automotive electronics, electric power, and many other industrial grade and above the customer. Enterprise after more than ten years of development and accumulation, improve brand awareness, market share also expanded accordingly. Our company has become the major national manufacturers of long-term suppliers. We have branches in shenzhen, Hong Kong. The company's development cannot leave the new and old customers support and advice, we will continue to strive to do: "provide adequate for domestic and foreign customers, the economy, the original product. In a competitive price - quality products excellent service based on the market and the major equipment manufacturers.