How to install the artificial grass:
1.1. Inspection:
Inspect the foundation to ensure it has a flat and smooth surface
and appropriate slopes,making sure the foundation is qualified for
installing artificial turf;
1.2. Measuring:
Locate the centers of the ground and the two semicircles, and
according to these three centers locate the intersecting point of
half-way lines and touchlines, and then determine the positions of
functional lines and spot by using Pythagorean proposition;
2. Turf layout:
According to drawing, position the turf rolls on the exact places
along the touchline.The turf with white lines should be placed at
the half-way lines and base line, and then lay out the rolls in
order;
3. Preparing functional line:
Cut white turf piece into strips(width to be as per actual need)
for white functional lines(half-way lines, base lines etc.), and
put them aside preparing for Green Artificial Grass Carpet
installation;
4. Seaming:
The adiacent turf rolls must be join together with 20~30mm excess
on both sides, then cut the excess part with a special cutting
knife on the joint center and trim the cut to make the turf join
perfectly together. After trimming, place the seam tape on the
foundation surface and make the joint line of turf right on the
middle of the seam tape. And then apply the adhesive to seam tape
evenly with a rubber spreader, and press down the turf on both
sides of the seam tape firmly;
5.1. Installing functional lines:
Measure and re-position the functional line on the turf that has
been all well joined on the ground. Cut the turf out and place the
seam tape beneath the cuts, then spread the adhesive on the seam
tape and install the well-prepared functional lines, press it
firmly to ensure the immobility.
5.2. Trimming:
Inspect the finished lawn, if any uneven found, cut it open, pull
it straight and cut the excess away.And rejoin it with adhesive;
6. Infilling sand:
Place the sand piles on the finished lawn on different spots evenly
at a distance of 4m from each other,then spread them evenly on the
lawn(the quantity if sand depends on the pile height of the turf).
Afterwards, use the combing machine to sweep the sand into the
fibers and to comb uo the fibers. Do this process once
longitudinally and transversely.
7. Infill rubber granules:
After sand infilling, Place the rubber granules piles on the lawn
on different spots evenly at a distance of 4m from each other, then
spread them evenly on the lawn(the quantity of sand depends on the
pile height of the turf). Afterwards, use the combing machine to
sweep the sand into the fibers and to comb up the fibers. Do this
process once longitudinally and transversely.
8. Combing:
Once the infilling is finished, comb the turf once more with the
combing machie to make the fibers point up to the sky.
9. Inspection:
Inspect the entire finished lawn as per concerned standards and
requirement.If any defects found,correct it.
