Battery To Starter Cable With Terminals And Terminal Covers
Precautions for removing the car battery starting cable
1. Do not disconnect the battery cable before reading the fault
code
After the power is turned off, the fault code of the control unit
will be automatically eliminated, which will affect your judgment
of the fault. Therefore, the current fault code must be recorded
before the power failure, and then consider the power failure.
2. Do not disconnect the battery cable when the ignition switch is
in the ON state
Sudden disconnection of the battery cable will cause the coil in
the circuit to generate self-inductive electromotive force, which
will easily damage the computer board or sensor.
3. The fault code cannot be cleared by removing the battery cable
at will.
For some engines, disconnecting the battery cable can clear the
currently stored fault codes, but for some engines, after
disconnecting the battery, the anti-theft and navigation will be
locked. So it can't be cut off at will.
4. When replacing the battery, first disconnect the negative
electrode, then disconnect the positive electrode, and install it
in the opposite way.
Because cars are all negative ground, negative ground can prevent
electromagnetic interference. When a power outage is required
during vehicle maintenance, as long as the battery negative stage
is removed, it is not easy to cause a short circuit.
5. When installing the battery positive and negative cables, be
sure to install them in place and tighten them with standard
torque.
Re-maintenance must be careful and careful, and every link must be
done in one step to prevent excessive failures and cause customer
complaints.
Product parameters:
products name | Battery To Starter Cable With Terminals And Terminal Covers |
Material | Wire: high temperature resistant wire or irradiated wire [QVR-105℃,
AEX(F), STX, SGX];
Bellows: Nylon (PA);
Dust jacket: fluorine rubber, EPDM or neoprene;
Tape: cloth base or high temperature resistant tape (gray);
Terminals: matt tin plated; battery clips - copper tin plated or
zinc, lead-tin alloy;
Heat shrinkable tube: cross-linked polyolefin (PE), continuous use
temperature -55~125℃. |
Connector | All kinds of connectors are available |
Color | All colors are available |
MOQ | Welcome Small quantity, even 100pcs |
Standards | Under IPC/WHMA-620 Standards |
Quality | 100% tested before delivery, Never use Fake materials |
