Mining Equipment Gear Reducer Gearbox And Planetary Gear Reducer
1. Introduction of high-power reducer and gear reducer gearbox
Since 1970s, our institute has introduced a variety of complete
sets of reducer design, manufacturing, installation and maintenance
technology from RENK Company of Germany, F.L. Mid-th Company of
Denmark, CITROEN of France and other companies. Over the years, we
have absorbed advanced technology from SIEMAG, MAAG, , KHI and
other companies. The advanced technology mentioned above and the
new technology developed through improvement and innovation over
the years have been integrated into product design and development,
forming their own intellectual property rights, developed a number
of characteristic technical products, such as 2000kW planetary
reducer; The largest 4×5000kN ship lift reducer; The first MB25
hard tooth surface, large torque, multi-point meshing, double split
edge transmission device for cement mill in China; And KF300
reducer with the largest φ 1100mm punch in China, its rated output
torque is 3000kN. M, the actual up to 4500kN. M.
2. Case introduction of characteristic reducer and gear reducer gearbox
(1) Sugar pressing equipment supporting a series of planetary gear
reducer and a series of parallel shaft cylindrical gear reducer;
(2) Power generation, coal grinding equipment supporting series of
reducer, and 200 ~ 2000kW series of planetary gear accelerating
device;
(3) Series parallel shaft cylindrical gear reducer for lifting and
transporting equipment;
(4) Universal equipment supporting series of planetary gear
reducer, and a series of parallel shaft cylindrical gear reducer;
Cement production line mill transmission device is a typical
high-power, low-speed and heavy-duty transmission device, which can
also be used in mechanical transmission under similar working
conditions. The input revolution of the transmission device is not
more than 1000r/min, and the ambient temperature is -10 ~ 5℃ (if
the temperature is lower than -5℃ or higher than 30℃, lubricating
oil heating or cooling device shall be attached). The device can be
used for positive and negative operation.
