NFPA Fire Fighting Uniform Turnout Gear firefighter uniform
It has four layers,including flame retardant, waterproof and
breathable layer, thermal insulation layer and comfort layer.And
these functional layers make sure the uniform has the performance
of fire prevention, permanent flame retardance, acid and alkali
resistance, oil resistance, antistatic, wear resistance, waterproof
and breathable, etc. The innermost lining of sleeve cuffs,cloth
hem,and trouser cuffs are produced by the Anti-watering material of
STEDPRENE FR. The shoulder pad is made of outer shell material with
Kevlar felt,and knee pad is made by STEDSHIELD FR with Kevlar felt.
Besides, there are some convenient and unique designs of this type
uniform,such as one radio pocket on left chest, one flashlight hook
and adjustable fastener on right chest, two cargo pockets on jacket
hem and trousers sides.
Specification
| Item | Firefighter uniform |
| Outer Layer | PBI Matrix |
| Water proof layer | Stedair 3000 |
| Heat insulation layer | 2-Layer aramid felt quilted to aramid woven fabric/fr viscose woven
fabric |
| Reflation tape | 3m scotchlite 9587,3inch wide |
| Standard | NFPA 1971:2018 |
Maintenance Methods of Firefighting Uniform:
After taking firefighting uniform off each time, check its
condition,especially check if it is worn.
If the applier want to remove the residual dirt on the fire suit,
tap water and neutral soap can be used, or detergent can be used if
necessary. Just clear the contaminated part, and carefully not to
damage the outermost layer.
If there is not very serious burn mark or wear on the surface of
uniform, repair the damaged parts. If there is damage on the
outside of the clothes, please replace .
Other Recommended Products
