300T Thixomolding Magnesium Alloy Die Casting Machine Semi To Solid
Process
Technical characteristics
1. When the equipment is in standby mode, the noise does not exceed
75 decibels when moving up and down fast.
2, adopt four column three plate structure, the vertical accuracy
of the movable plate is controlled by four guide sleeve, the
parallel accuracy of any point of the lower working face and the
upper working face is less than 0.1mm.
3, with waste blowing assembly, and in the middle of the working
table is opened with waste dropping groove.
4. The position of punching dead center of hydraulic press is
generally controlled by pressure switch and position sensor.
5, with automatic counting function, manual can be pressed on the
mold stop in any range of stroke, equipped with emergency pick up
button, can also be equipped with infrared guard device.
6, pressure, stroke, punching speed, blowing time, closing height
can be adjusted by the customer, convenient operation.
7, the hydraulic system built in the bottom of the tank, clean
appearance, stable.
8. The output range of this series hydraulic machinery is 5-100TF
(1TF = 1000kGF =9.8KN).
9, the series of hydraulic machine tools with 2-20mpa liquid
pressure as power source, external three-phase AC380V 50HZ or
three-phase AC220 60HZ AC power supply.
The series of equipment to liquid as a medium to transfer energy,
the use of mother cylinder hydraulic circuit, low oil temperature,
air travel speed are above 150MM/ s, work speed of 30MM/ s below.
Scope of application
1, all kinds of aluminum magnesium alloy die casting trimming
plastic.
2, the most widely used in aluminum magnesium alloy mobile phone
products, automobile, motorcycle die-casting parts, kitchen
utensils, food and other fields.
3, metal and non-metal plastic trimming.
