Discontinuous Exterior Decorative Wall Panels Rock Wool Sandwich
Panel Production Line
Specification
Suitable for ceramic board, calcium silicate board, metal board,
etc.
Suitable for polystyrene board, extruded plastic board,
polyurethane foam board, rock wool board, etc.
1. Production speed of production line: 3-4pcs/min (about 6m
finished products)
2. Product drawings are shown in the drawings signed by both
parties
3. Production line covers an area of about 48m×3m wide×1.8m high
4. Production line labor: 3 persons
5 production line power: about 60KW
6 production line environment working environment requirements
1) Ambient temperature: 0℃～50℃, relative humidity: ≤90% (25℃)
2) Three-phase AC power supply: 380V (±10%), 50HZ
3) Compressed air: 0.5～0.6Mpa
Process
Automatic Decoiler→feeding and heating platform→gluing
part→composite material feeding part→preheating platform→laminated
lamination→finished product discharging platform→automatic
palletizer
Machine List
| NO. | Parts | Quanity (set) |
| 1 | Decoiler | 2 |
| 2 | Leveler | 1 |
| 3 | Punching device
(6 sets of punching dies) | 1 |
| 4 | Roll forming machine | 1 |
| 5 | Bending device | 1 |
| 6 | Out table | 1 |
| 7 | Preheating device | 1 |
| 8 | Automatic spray device (3meters) | 1 |
| 9 | Feeding device for the rockwool | 1 |
| 10 | Preheating device(2.5 meters) | 1 |
| 11 | Assembling machine 1250mm&22meters | 1 |
| 12 | Output table | 1 |
| 13 | Control box | 1 |
| 14 | Auto stacker | 1 |
Main Technical Parameters
1. Rolling material material: material for color coated coil, steel
plate, aluminum plate
2. Rolled material thickness: 0.5-1.2mm
3. Rolled material width: 350-1250mm
4. Inside diameter of rolled material: φ500-620mm
5. Production line production speed: 3-4pcs/min (about 6m finished
products)
6. product drawings see both sides signed drawings
7. precision and technical requirements of the manufactured parts:
length ±1.0mm, port distance ±1.0mm, straightness 0.5mm/m, width
tolerance ±1mm, punching notch position degree error: ≤0.3mm;
symmetry ±1.5mm; basic square plate and superimposed fit: 99% for
plane fit, 99% for bevel fit. Punch shall not have burr, should be
flat punching smooth. (Other technical requirements not specified
are subject to the requirements of the drawings confirmed by both
parties under seal)
8. Production line covers an area of approximately 35m x 3m wide x
1.8m high
9. Production line labor: 2 people
10. production line power: about 22KW
11. production line environment working environment requirements
1) Ambient temperature: 0℃～50℃, relative humidity: ≤90% (25℃)
2) Three-phase AC power supply: 380V (±10%), 50HZ
3) Compressed air: 0.5～0.6Mpa
12. appearance quality of square plate: no obvious zinc bloom off
the surface, loss of surface galvanized layer ≤ 10g/m2, no burr in
punching notch.
13. Appearance requirements after punching: smooth and burr-free
inner wall and perimeter of the hole.
Application
