Aluminum Heat Exchangers Water Cooling Plate for Battery Pack
Trumomy, which is specilized in providing various battery cooling
solutions. Liquid battery cooling is the common way for Electric
Vehicle battery cooling. It uses a liquid coolant such as water, a refrigerant, or ethylene
glycol to cool the battery. The liquid goes through tubes, cold
plates, or other components that surround the cells and carry heat
to another location, such as a radiator or a heat exchanger.
Components carrying the liquid prevent direct electrical contact
between the cells and the liquid coolant.
We specilized in:
1) Stamping type cooling plate for prismatic cells / battery pack.
2) Extrusion snake tube for cylindrical cells, such as 21700,
18650, 3270, 4680 big cell.
3) Roll bonded cooling plate
Our Advantages:
1) Full solutions for battery cooling. (According to your module
provide customized cooling plate)
2) Design service, we have R&D department, can do design
finalization, flow and heat simulation.
3) CNC centre to make customized inlet/outlet connector.
4) Thermal Interface Material, such as thermal silicone pad,
Insulation coating etc.
Detail Products
Chemical composition
| Alloy | Si | Fe | Cu | Mn | Mg | Cr | Zn | V | Ti |
| 1050 | ≤0.25 | ≤0.40 | ≤0.05 | ≤0.05 | ≤0.05 | --- | ≤0.05 | ≤0.05 | ≤0.03 |
| 1100 | ≤0.95(Si+Fe) | | 0.05~0.20 | ≤0.05 | -- | -- | ≤0.10 | --- | --- |
| 3102 | ≤0.40 | ≤0.70 | ≤0.1 | 0.05~0.4 | --- | --- | ≤0.3 | --- | ≤0.10 |
It can be customized according to customers' request!
Mechanical Properties
| Alloy | Temper | Tensile Strength | Yeild Strength | Elongation |
| 1050 | O/F/H111/H112 | ≥65MPa | ≥200MPa | ≥25% |
| 1100 | O/F/H111/H112 | ≥75MPa | ≥200MPa | ≥25% |
| 3102 | O/F/H111/H112 | ≥75MPa | ≥200MPa | ≥25% |
| 3003 | O/F/H111/H112 | ≥75MPa | ≥200MPa | ≥25% |
FAQ:
Q: Are you a trading company or manufacturer?
A: Yes,we are a factory with more than 10 years history in this
industry.
Q: What is your terms of payment ?
A: Normally 30% TT in advance, balance paid before shipment.
Q: How long does it take for samples and mass production?
A: Usually it will take 15-20 days for new molds and free samples
(within 5 kg),;after confirmation, 25-30 days for mass production.
Q: OEM/ODM available?
A: Yes,we can!
Q: Could you provide sample?
A: Yes, We are honored to offer you samples for quality check.
Q: Is sample order accepted?
A: Yes,we accept sample order and we can provide design service!
