UV Light curing equipment headlamp rack and small lamp rack link
line part
DAO UV curing instructions
Setting items: pipe diameter, thickness, length, selection of light
chain, power, speed, and the time interval between bulb opening and
closing. (it shall be set according to the technical parameters of
the hose material manufacturer)
Select to turn on the bulb automatically or manually according to
the site conditions.
When the temperature starts to rise:
Air temperature: no higher than 90 ° C and no higher than 120 ° C.
Material temperature 1: front material temperature, not less than
70 degrees, not more than 120 degrees.
Material temperature 2: rear material temperature, not less than 50
degrees, not more than 120 degrees. (recommended temperature, the
actual situation depends on the hose manufacturer, equipment,
internal conditions of on-site pipelines, etc.)
During the first three meters, pay close attention to the
temperature changes in the three areas and adjust the curing speed
at all times. After it is normal, the speed can be set to a fixed
value, such as 90cm/min. If the temperature rises too fast, the
speed can be increased by 120cm/min. If the temperature increases
slowly, it can be suspended. The operator pays close attention to
the whole process and adjusts it at any time.
At the last meter, it is switched to manual control and the camera
is switched to rear view to ensure the safety of the light chain.
| How | NO-DIGGING |
| Application | Public sewers |
| Length | 0.8m |
