Features of scrap radiator recycling machine
1. Easy operation, small land occupation.
2. High performance with 100% separateing rate.
3. Long working life and large capacity
4. Environmetal and no noisy.
Material Preparation of scrap radiator recycling machine
1. Iron heads of radiators must be cut off the two sides of
radiators;
2. Radiators must be cut with a band saw according to the width of
each Material Inlet;
3. Radiators that are more than 2 layers must be cut into one layer
and two layers with the band saw;
4. Do not feed radiators into wrong Material Inlets (three inlets
each are for 19mm, 21mm, 25mm radiators respective);
5. This machine is suitable for processing one layer radiators when
it is shipped to customers. When you need to process two-layer
radiators, just remove the iron covers from the Lower Blade Roller
to expose the blades.
6. When two-layer radiators are processed, the left side of the
radiators shall touch the left side of each Material Inlet, and the
first copper pipe in the Upper Layer to the left side of each
Material Inlet must be nearer than the first copper pipe in the
Lower Layer to the Left Side of each Material Inlet.
7. For both one-layer and two-layer radiators, the left side of
radiators must touch the Guiding Rulers and are radiators must be
fed into Material Inlets along the guiding rulers.
8. When radiators are fed into Material Inlets correct, each
Feeding Gear at the Material Inlet must be at the middle of each
two copper pipes; or copper pipes and aluminum will not be
separated.
9. Twisted radiators can not be processed.
Trouble-shooting of scrap radiator recycling machine
1. In radiator separating, if radiators move towards left direction
or right direction, check if the two Adjusting Wheels of each pair
are on the same level.
2. When abnormal noise appears in working, check the working
conditions of transmission gears, bearings and Speed Reducer as
well as motors.
3. When radiators can not be cut from top to bottom, check if
Triangle Belts are loose which causes slipping; or check if the
blades become blunt.
4. After working for a period, Speed Reducer lubricant shall be
replaced; check if screws become loose or not; check if blades and
Feeding Gears become loose or not.
