Part I. How to use Pneumatic waste stripper properly.
1. Pneumatic waster stripper needs at least 5p air compressor or above with large enough connected pipes. Ensure the powerful rotation of the wheel.
2. First, make sure that the pneumatic waste stripper is connected with the air source; ensure the air pressure is 8kgs and the air pipe can work normally at 8*12m/m with maximum length of 15 meters. Otherwise it cannot work.
3. Turn on the sliding switch before work, or adjust the pressure valve to the maximum.
4. Inject special pneumatic tool oil or white mineral oil at air inlet of the waste stripper, lubricate air motor.
5. Press the platen and begin to work.
6. Stack the cardboard papers which need to remove the waste part neatly and four sides in flat.
7. Drive the chain using hand, check whether it can roll freely before open the air pressure. Press the top of the cardboard stack using iron plate. The four sides of the cardboard must have cutting edge. The distance of the cutting edges should be fit the
cardboard stacking position. Arrange appropriate gap on the cutting edges, make sure waste part connects with the products. So strip the waste corner must ≥5mm, easy to make breakpoint.
8. Pneumatic waste stripper is different with other pneumatic tools. It need a week run-in period. And maintain unimpeded sliding between chain and sprocket wheel. Each half day drop a few drops of oil on the chain, to reduce friction and prolong its service time.
9. Before use each time, drop 3-4 drops of pneumatic tool oil on the air inlet of waste stripper, and idling for 2-3 seconds.
10. Pneumatic waste stripper is a precision pneumatic tool. Please don’t throw it hardly. Waste stripper’s maintenance is more important than repairs.
Part II FAQ when use the waste stripper
1. Pls ensure to add some gear chain oil timely as it takes about one week for run-in period.
2. Waste stripper did not rotate
(1) Lower air pressure, or without installation of oil water separator shall cause rusty generator. Pls spray WD-40 anti rust agent to do the cleaning.
(2)When there is over tightness or with gear stuck, pls disassemble the outer cover, adjust the sliding block to check whether the chain and gear is out of order.
(3)Pneumatic motor blade wear, please replace the blade.
(4)When the waste stripper is at work, the shredded paper will stuck into the chain. Pls take off the gas source and drop a few chain oils. Then use hand to make the chain rotate until the paper coming out. At the same time, the chain shall work by itself.
3. When the waste stripper works weakly
(1) Not enough air source pressure, pls check the air pressure and adjust
(2) Whether the Sliding switch is broken or not, Pls change it if necessary.
(3) Motor blade is with heavy ware, pls change it to 4 pieces.
(4) The chain is too tight, pls loosen the chain to suitable position to ensure non resistance sliding.
(5) Whether the bearings are broken. Pls use high quality imported gears.
(6) Pls add a few drops pneumatic tool oil to the air inlet to keep the blades smooth.
(7) Due to a large number dust will be occurred after using, pls work with a dust blowing gun to ensure that the chain is clean and tidy.
4. Waste stripper cannot work
(1) Pls suitably adjust the paper grasp direction to best paper stripping position when the waste stripper unable to grasp paper.
(2) Pls change the chain when it’s wear out and unable to catch the paper.
(3)Pls adjust the sliding screw to suitable position and fix it firmly when the chain is loose. Pay attention to the length that is precise.
Remarks:Pls add a few 40# machine oil to the chain each time before use and make it work non load for one minute. Any violation of
this requirement will result in severe wear of chain teeth and life time reduction.