PLC intelligent control, independent liquid crystal display can see
the running process of the machine more clearly and
comprehensively, which is convenient, quick and easy to use,
real-time monitoring, real-time adjustment, more accurate,
high-efficiency production, and the edge sealing effect is not
compromised.
The pre-milling system corrects the plate workpiece before
lamination. The pre-milling device uses double milling cutters to
re-modify the corrugated traces caused by panel sawing to achieve
better edge sealing effect. The milling cutter motor will pass the
pressure The cylinder is completed, before reaching the end of the
workpiece, the cylinder will lift the tool, after passing the end
of the workpiece, the tool will return to the working position
immediately.
The gluing system is used to apply the glaze melt glue on the edge
of the workpiece. The gluing and edge-sealing device makes the
edge-sealing plate and the edge-sealing material evenly gluing
through a special mechanism to ensure stronger adhesion. , the glue
will be melted in the glue melting container, the glue roller will
transfer the hot glaze glue to the workpiece by rotating, and the
quantitative device will control the supply amount and adjust the
distance between the glue application shaft and the workpiece.
The end trimming system is used to cut off the cutting components
that exceed the front and rear end laminations. The flush device
moves through precise linear guides, and adopts mechanisms such as
automatic mold tracking and high-frequency electrode rapid cutting
to ensure that the cut surface is smooth and smooth. The cutting
unit is used for sawing of super high sections of lamination. The
edges are right-angled or beveled by rotation, both of which are
done by scraping the edges. A cutting assembly consists of two
unrelated cutting units.
Rough trimming device, the cutter at the rough trimming part is a
flat knife, which is used to trim the excess edge sealing material
on the upper and lower parts of the edge banding of the processed
sheet.
Finishing device, the finishing knife is R2 inclined knife, which
can leave 5-6 wire allowance for the next scraping process. The
automatic tracking of the mold and the high-frequency motor are
used to achieve fast cutting, and the R2 inclined knife is used to
repair the radian.
Scraping device, profile scraping, is used to eliminate the
secondary wave marks caused by the cutting process of non-linear
motion of trimming, so that the upper and lower parts of the plate
are more smooth and tidy. better.
The polishing device cleans the processed plate with a cotton
polishing wheel, removes excess glue stains, and makes the edge
banding section smoother and tidy through polishing.
