Dorit Cheapest And High Quality Dental High Speed Handpiece With
Anti-Retraction Head
High speed handpiece Description
Standard Head Dental High Speed Dental Handpiece With Four Spray
With Anti-Retraction Head
Push button type high speed handpiece, four water spray,
anti-retraction system, 2 holes 4 holes, super torque
2/4 Hole High Speed Handpiece Technical Data
| Product Name | Four Spray High Speed Handpiece |
| Quattro spray 3 way spray 3 air 2 hole / 4 hole 2 hole / 4 hole 2 hole / 4 hole |
| |
| |
| Chuck type | Push button |
| Noise | ≤70dB |
| Head diameter |
Φ11.2mm(standard) |
| Bur applicable |
Φ1.59mm-Φ1.60mm |
| Rotation speed |
300,000~420,000rpm |
| Chuck system | Push button |
| Power | 22W(standard) |
| Light brightness | 25500lux |
2/4 Hole High Speed Handpiece Product Description
1. German ceramic ball bearing; open style cartridge.
2. Four separate air and water spray, with anti-retraction head, effective cooling for bur and treating contact surface.
3. Medical type Stainless steel body, Light weight 55g( same as one
egg).
4. Streamlined design, comfortable for hand feeling, easy to clean.
5. 1 year warranty.
6. Unique electric generator, just a little air can generate
sufficient power
7. Self-illumination without connecting circuit
8. Perfect stable and reliable performance
9. Push Button cartridge
10. 135°C Autoclavable
11. Four water spray, more ideal cleaning effect
12. High-grade material with a stylish design
13.The ball bearing is steel ball to lead a longer life span
14.Push button,chang the burs more easily
15.Real steel ball bearing ! Low noise
Product details
Four-point spray; Water-vapor separation; Anti-back suction sanitary head |
2 holes 4 holes optional |
Ceramic ball bearing Myonic, German Ceramic bearing |
Food grade 304 stainless steel body and head |
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on
dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle ,
fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole
1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick
connector ) two kinds of styling , make the right amount of
lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine
the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth
handpiece head ( make sure the needle does not touch the diamond
burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is
in white gauze on any stain. If there are stains on the white gauze
, again, add oil , starting from item 4 continued routine
maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high
pressure sterilization
Instruction:
After each treatment,Sterilizing handpiece in autoclave according
to the following steps:
1.Remove the bur and brush clean handpiece, clean outside of
handpiece with an alcohol solution.
2.Lubricate handpiece, each times drop two drops inside of air
inlet pipe.
3.Place into autoclaving pouch and mark.
4.Autoclave the handpiece for 12 min. at 135ºC.
