Henan Dorit Biotechnology Co., Ltd. always takes “quality bearing
responsibility, technology creating advantage, innovation leading
the future ” as its development concept, and conscientiously
implements to the operation, management, product research and
development and manufacture. Henan Dorit specialize in dental
treatmen equipment area, main product contains high or low speed
dental handpiece, ultrasonic scaler, three-way syringe and Dental
LED Curing light.
During the process of serving global oral industry , Dorit takes
every step as walking on the thin ice. We not only innovate
bravely, but also go ahead steady step by step. During the process
of serving global oral industry , Our products have been bought in
more than 100 countries abroad, such as the United States, Germany,
Canada, Mexico, Brazil, Vietnam, Sri Lanka, Iraq, etc., and are
well received by customers.
Our target is“share wealth with the world;Soul moisten in the
dental profession” We are adhering to the company’s mission
"Quality assurance is the responsibility, Technology is the
advantage, Innovation leads the future", and implement these
philosophies to the company’s management, product R & D and
manufacturing. Dorit Company continues to absorb high-grade,
precision and advanced talents to integrate related industry
resources in order to offer better and more comprehensive services
to the society.
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on
dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle ,
fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole
1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick
connector ) two kinds of styling , make the right amount of
lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine
the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth
handpiece head ( make sure the needle does not touch the diamond
burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is
in white gauze on any stain. If there are stains on the white gauze
, again, add oil , starting from item 4 continued routine
maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high
pressure sterilization
Instruction:
After each treatment,Sterilizing handpiece in autoclave according
to the following steps:
1.Remove the bur and brush clean handpiece, clean outside of
handpiece with an alcohol solution.
2.Lubricate handpiece, each times drop two drops inside of air
inlet pipe.
3.Place into autoclaving pouch and mark.
4.Autoclave the handpiece for 12 min. at 135ºC.
