J05E / J08E Crankshaft Conneting Rod 13260 - E0100 - 01 / SK350 - 8
specification
| Model : J08E | Number of cylinders: 6 cylinders |
| Engine marker: Hino | Excavator model: SK200 - 8 / SK250 - 8 / SK350 - 8 |
| Engine model: Electric injection | Condition: Used |
| Weight: 1.87kg | Big end borel: 135mm |
Description
Definition
The connecting rod is defined as it is a mechanical component that
helps to connect the piston and crankshaft of the engine. In other
words, you can say it acts as an intermediate member between the
piston and the cylinder.The rod which is facing the piston side is
termed as a small end. And which is on the crank side is termed as
a bigger end.
How does the connecting rod work in the engine?
Pull and push in the piston receive the piston pin,and then the
connecting rod acts as the transfer of the pull and pushes from the
piston pin to the crank pin. that is, in any internal combustion
engine with the help of it, the reciprocating motion is converted
to rotary motion.
In the design requirements of the rod, the bearings are connected
with the cap so that we have accurate and smooth rotation. Same as
bush near the smaller end to fit to get accurate and smooth motion.
Connecting rod is the link that transmits forces between the piston
and the crankshaft. So Connecting rods must be strong enough to
remain rigid under load and yet be light enough to reduce the
inertia forces that are produced when the rod and piston stop,
change direction, and start again at the end of each stroke.
What is the purpose of a connecting rod?
The con-rod connects the piston to the crankshaft to transfer
combustion pressure to the crankpin. There are bearing portions at
both ends, the piston side is called the small end, and the
crankshaft side, the big end.
What causes a broken connecting rod?
Common causes of connecting rod failure are tensile failure from
high engine speeds, the impact force when the piston hits a valve
(due to a valvetrain problem), rod bearing failure (usually due to
a lubrication problem, or incorrect installation of the connecting
rod.
