Replacement Goyen CA25T 1" Dust Collector Pulse Jet Valve
Right Angle threaded solenoid pulse valve is constructed with
aluminum alloy body suitable for dust collection applications, in
particular for cleaning bag filters.We have three types right angle
type with dresser nut DD & manifold mount type MM & Flanged type
FS, with different connection form. It is 2-way dust collector
valve used for pulsing large volumes of air into filter bags for
removal.
Order Code Example:
CA25T
CA:The Pilot Type is Integral Pilot .
25:Valve Size is 25mm, Port Size is G1 Inch .
Dimension of CA25T Goyen Type Pulse Jet Valve:
Video of CA25T Goyen Type Pulse Jet Valve:
Technical data of Right Angle Pulse Jet Valves:
Model No | | | | | | | | |
Nonimal size | | | | | | | | |
Port Size | | | | | | | | |
Working pressure | |
Temp. range | |
Relative humidity | |
| |
Voltage | |
More Goyen Type Pulse Valve For You to Choose:
Threaded Type Immersion Type Dresser Nut Type Flanged Type
RCA Series Solenoid Coil Armature Assembly Pulse Controller
Working Principles:
The electromagnetic pulse valve is composed of electromagnetic
pilot operator, diaphragm and valve body. Due to difference of
pressure acting on two sides of the diaphragm, the diaphragm is
pressed closely against the outlet of valve to keep the valve stays
in “closed” position.
When energized by an electric signal from the controller, the
electromagnetic armature will move to open the discharge opening of
back cavity.
The compressed air in back cavity bursts out to relief pressure and
pressurized air in front cavity pushes up the diaphragm to open the
main outlet of valve, then the electromagnetic pulse valve opens
and starts to blow.
When the signal disappears and the spring works immediately to send
the pilot operator back to its original position and close the
discharging opening. The diaphragm will close the passage by the
effect of the pressure in the front cavity and the spring. The
pulse valve stops blowing.
The orifice in the diaphragm damps the airflow when the armature is
lifting up for releasing the pressure. When the discharge hole
closed, the pressure gas will fill into the front cavity to close
the passage by the diaphragm. The pulse valve stops blowing.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
