1. 35mm standard DIN rail installation, complying with standard DIN
EN50022. Or front board installed (mounting holes center distance
63 mm), users can choose any one by themselves.
2. Ten pole width (Modulus 12.5mm), complying with standard JB/T7121-1993.
3. Type S wiring (Inlet from bottom, outlet from top),use CT connect operation, may select 27 CT ratio, the meter will read directly after set,
and needn’t multiplied by CT rate.
4. 7 digits LCD display, 5+2 digits(99999.91kWh,Only when CT ratio 5:5A) or 7 digits display. It is choose by the CT ratio which is set.
5.Standard configuration one port of active pulse output passive and one port of reactive pulse output passive(polarity),The output rate are 0.01, 0.1, 1, 10kWh or kvarh/Pulse.Users can choose any one by themselves. May select one port of active pulse output passive and one port of reactive pulse output passive (nonpolarity). And contact
with all kind of AMR system conveniently,Complying with standard IEC 62053-31 and DIN 43864. (Please
specified when ordering)
6. Standard configurationthere are far infrared and a port of RS485 communication data, communication
agreement complying with standard DL/T645-1997. May select without
function of communication data. (Product Configuration code is NC)
7. Six LED instructions power supply state and signal of active energy impulse and reactive energy impulse and data communications state.
8. Automatic detection the direction of the flow of load current. And instructions by one LED.
9. Single direction three components measure three phase four wire
active and reactive energy consumption. It is nothing with direction of
the flow of load current. Complying with standard IEC 62053-21and IEC 62053-23.
10.Standard configuration short terminals cover, may select
extension terminals cover, in order to protect to use safety.
(Product Configuration code is AF).
