Description:
We use MWQ-LD as the emitting component of 650 series fiber fault
locator. Driven by constant current source, the indicator can emit
stable red laser. The product can be used to inspect fiber failure
when they connect with optical interface and be inserted into
single mode or multi mode optical fiber. It is indispensable tool
in fiber project constructing, fiber net-work maintaining, optical
component manufacture and research.
Technical parameter:
Wavelength of optical source: 650+10nm
Applicable fiber type: single mode or multi mode
Output power in single mode: 15 mW
Power: two 1.5V batteries
Continuous working time of power: ≥20 hours
Working temperature: 10~+60℃(not dewing)
Storage temperature: -40~+85℃
Material of the shell: Cu-alloy or stainless steel
Dimension: φ24×170mm (without interface)
Weight: 160g (without batteries)
Outer structure:
1-dust cap 2-optical interface 3-head of the indicator
4-LED 5-switch 6-body 7-tail
Usage:
1. Screw off the tail, then put two 1.5V batteries into the tail,.(Caution: anode of batteries point to bottom of the locator, cathode
of batteries contact cathode of the locator).
2. Connect the body with the tail, and open dust cap, then press
the switch. You will see the red laser emitting from the optical
interface, at the same time, LED will be lighted up (Please don’t
stare at the beam, for fear of damaging your eyes).
3. Press the switch again, light-emitting changes to pulse mode,
and LED synchronize with light-emitting (pulse frequency will be
controlled at 0.5-2.0 Hz ).
4. Press the switch again, the optical source will shut, and there
is no more light. Meanwhile, LED put out (Switching cycle mode is:
continuous-pulse-shut).
5. You should insert the fiber which you want to inspect into
optical interface, then press the switch to choose working mode of
the light source (continuous or pulse).
6. When you finish the inspection, please screw on the dust cap. If
you don’t use the indicator for a long time, you must take out the
batteries, in case that batteries rot and destroy light source.
Maintenance and attentions:
1. Laser is harmful, so especially, you must protect your eyes.
When the LD working, please don’t let your eyes exposure to laser.
2. Generally, the higher is temperature, the shorter is life of the
LD. Avoiding high temperature when you use it.
3. The head of fiber must cleared up while the LD operates.
4. If don’t use this light source, please screw on the dust cap in
case that the dust fall into.
5. Take out the batteries when you don’t use it.
