Motor Control Failures 4D Probe Motor Repair GE RAB2-5-RS
We provide repair service on most common probes, 3D/4D transducers,
and Endo/TEE probes.
With 10 years experiences on probe repair, our technical engineer
team own the most advanced probe repair processes, which enables us
to fix probes from a basic lens fault to 4D /TEE fault.
Once repaired, all probes will go through an extensive testing
process ,until reach their optimal condition.
Other hot GE models we can repair:
| GE | C1-5-D |
| GE | C1-5-RS |
| GE | 4C |
| GE | 4C-RS |
| GE | 4C-A |
| GE | 4C-D |
| GE | 4C-SC |
| GE | E8C/E8C-RS |
| GE | E8CS |
| GE | RIC5-9-D |
| GE | 3CRF-D |
| GE | C1-6-D |
| GE | RAB4-8-RS |
| GE | RAB2-5-RS |
| GE | 6S-RS |
| GE | 12L-RS |
| GE | 3SC-RS |
| GE | L6-12-RS |
| GE | 11L |
| GE | 11L-D |
| GE | 12L-RS |
| GE | 8C |
| GE | 3S |
| GE | 3S-RS
|
Common ultrasound Probe Damage(Specialty 3D/4D Volume probes)
| Common ultrasound probe damage | Solutions |
| Lens cap damage | Lens cap replacement |
| Fluid and oil leaks | Lens cap replacement, oil reservoir repair and replacement |
| Cable cuts | Cable patches, possible cable replacement |
| Inoperative steering | Motor repair |
| Connector housing electrical damage | Minor electrical repairs, pin module replacement |
| Weak or dead elements, dropouts in an image | Array ball replacement, oil reservoir repair and replacement |
Warnings and cautions of ultrasonic probe
★ The ultrasonic probe is a valuable device. It must be careful in
the process of use. Avoid dropping, impact, or abrasion to
transducers.
★ When installing or removing the probe, first switch off the power
and then operate it carefully.
★ Avoid rapid and extreme temperature changes, as well as lengthy
exposure to direct sunlight or a strong ultraviolet light source.
★ Do not use sharp objects to penetrate the acoustic lens.Once the
acoustic lens is damaged, the coupling gel is easy to enter the
interior of the probe and damage the piezoelectric element.
★ Do not soak transducer in any liquid above the recommended level
as stated in the user manual for your system, please operate
according to the manufacturer's instructions, otherwise it will
lead to circuit failure or even burn out.
★ Do not disinfect at high temperature, because the probe is
equipped with piezoelectric ceramics, high temperature will weaken
the effect.
★ Before use, carefully check whether the housing and cable are
damaged, so as to prevent the probe from high voltage injury.
★ After the probe is used, the residual coupling gel on the probe
must be wiped clean to prevent rats or other animals from gnawing
the lens.
