Electric CM602 Feeder Calibration Jig SMT Production Line
ORIGINAL SMT CM602 FEEDER CALIBRATION JIG
It is essential for this equipment that enhanced productivity ,
installation and quality improvement
As the high efficiency vision camera is asked in order to
investigate precisely and repair the error of device position
which results from the modification and wear of tape feeder in the
SMD device.
The Feeder, which supplies resources in the SMT production line,
should be under clear condition continuously
because it has relatively close correclation with the quality of a
current line, production efficiency and loss.
Convenience in use:
1. The acquisition for the rectangular coordinate of X-Y direction.
2. Check for the existence, transformation, user in the feeder
3. The installation is to euip it with actual device and
consolidation in feeder base
4. Lens` safe arrival part, CCD Camera, the precise micro
controller of X, Y, Z axis
5. The simple calibration for removing or taking feeder easily
6. It is correction as measurement with CCD Camera.
7. The use pressure is able to control in the regulator and air
cylinder.
8. Verification and correction available worker`s convenience and
well carriage by the work desk.
Overall size | 500 x 350 x 550 mm, L x W x H |
| Type | Electric |
| Monitor | 12" LED display, with cross mark |
| Camera | CCD , 50 times magnfication |
| Object Feeder | KME CM402 / CM602 |
