Aluminum Cable PVC Insulated PVC Sheathed NAYY VLV Power Cable
Feature:
The working temperature of NAYY insulated cable is the maximum
rated working temperature of the conductor 90℃; the maximum
temperature of the conductor short-circuit temperature shall not
exceed 250℃, and the longest time shall not exceed 5 seconds; the
installation and laying temperature shall be the cable installation
and laying temperature not lower than 0℃; the air laying is set to
the environment The temperature is 40℃; the soil lay is set to the
ambient temperature of 25℃.
Application:
This product is suitable for transmission and distribution lines
with AC 50Hz and rated voltage 0.6/IKV.
Product Standards:
This product is produced according to the GB12706 "Rated Voltage
35KV Copper Core, Aluminum Core Plastic Insulated Power Cable"
standard, and can also be produced according to the International
Electrotechnical Commission's recommended standards IEC, British
Standards, German Standards and American Standards according to
user needs.
Specificaiton:
| Product name | PVC Insulated Cable |
| Certifications | CE/CCC/ISO |
| Standard | IEC60502-1 |
| Rated Voltage | 0.6/1 KV |
| Conductor material | Aluminum |
| Insulation Material | PVC |
| Armoured Material | None/Steel Tape/Steel wire |
| Jacket Material | PVC |
| Number of cores | 1C,2C,3C,4C,5C,3+1C,3+2C,4+1C |
| Section area | 1.5MM2 - 400MM2 |
Extended information:
During the storage of the cable, the packaging should be
standardized to avoid long-term open-air sun exposure, and the two
ends should be reliably sealed. Long-term storage in a humid
environment is not allowed, and the cable reel cannot be placed
flat. The height of the tray should be considered and effectively
fixed during transportation. Several trays are not allowed to be
hoisted at the same time during hoisting, and it is strictly
forbidden to push down from a high place.
Special tools should be used for cable laying, such as pay-off
racks, guide rollers, etc., to prevent mechanical damage during the
laying process and keep away from heat sources. When laying the
cable through the pipe, the inner diameter of the pipe should not
be less than 1.5 times the outer diameter of the cable. When
multiple cables pass through the pipe, it is forbidden to squeeze
the cable. The total area of the cable should not exceed 40% of the
total area in the pipe.
