Horizontal Wholesale FTTH Fiber Pigtail Patch Cord Fiber Optic
Connector Heat Fiber Optic Epoxy Curing Oven
Description
Curing Oven is a type of universal curing oven for fiber optic
connectors, it is available for general connectors (such as
FC/SC/ST, MU/LC) after glue injecting. The heating board could
contain 100 connector ferrules at most. There is indicator light,
timer and temperature indicator. Simply operation and perfect
solidified effect.
Key Features
Input voltage: 220 VAC 50 Hz, or 110 VAC 50 Hz;
2> Horizontal Heating Board, convenient for putting ferrules and
connectors;
3> High efficiency, 100 ferrules heating synchronously;
4> Indicator shows temperature and time, high precision for
temperature control;
5> Automatically timing, and buzzer alarm reminding after time
is up.
Operating Instructions
Connected to single-phase power supply , 200V AC, 5A;
Switch power to ON, the red LED lights;
Program settings:
Press SETUP to display the corresponding control button into the
program settings, there are two settings, one for time, another one
for temperature;
Temperature control: set the curing requires constant temperature,
press UP and DWON to add and subtract, display the desired
temperature then press OK button to enter the time control. Factory
settings default temperature: 100℃;
Time control: when it shows entry time control, press UP and DWON
to adjust the time, time is the time required for curing continued
at a constant temperature. After adjusted the desired time, press
OK to enter operation. Factory setting: 30 minutes;
Curing, put the fiber connector into curing fixture, placing it in
oven, heating board then covered with dust cover;
Press OK, curing, curing furnace heating temperatures to the
specified time, timer automatic timer, temperature should keeping
constant, arrived at the designated time, curing oven stopped
heating, curing cycle ends;
If need cure again, time and temperature still stay the same then
put connectors into fixture, placing it in oven, press AGAIN for
next cycle of cure;
If you need to change the time and temperature, enter SETUP, adjust
them.
Technical parameters
| Dimension (mm) | 420 x 320 x 140 |
| Weight (kg) | 8.5 kg |
| Heating Temperature | 40 ~ 300 ℃ |
| Accuracy | +/- 1 ℃ |
| Input Voltage | 100~120VAC, 50Hz / 200-240VAC, 50Hz |
| Power Consumption | 800 W |
| Warm-up Time (approx.) | 15 min |
| Connector Type | 1.25 mm / 2.50 mm ferrule, FC/ST/SC/MU/LC |
| Capacity | 100, 80 |
Attention
This device uses high-precision integrated circuit design, with PID
function, need to prevent too hard and damage components during the
processing.
If the device has any abnormal display, please notify the supplier
for repair in time.
