Water control valve best products for import Plastic Float valve
float valve (also balltap or ballcock ) is a mechanism or machine
for filling water tanks,
such as those found in flush toilets, while avoiding overflow and
(in the event of low water
pressure) backflow.
It consists of a valve connected to a hollow sealed float by means
of a lever, mounted near
the top of the tank. The float is often ball-shaped, hence the name
ballcock. The valve is
connected to the incoming water supply, and is opened and closed by
the lever which has
the float mounted on the end. When the water level rises, the float
rises with it; once it rises
to a pre-set level, the mechanism forces the lever to close the
valve and shut off the water flow.
| Model | DN8WK-T |
| Port | 1/4” |
| Body | POM |
| BALL | PE |
| PLUG | SILICON |
| DIAPHRAGM | / |
| PRESSURE(Mpa) | 0-1.2 |
| Temperature (℃) | 0-80 |
| Flowrate (0.6Mpa) (L/MIN) | 2.20 |
Used | Small pond water tank, water purifier, water dispenser
flower gardening, animal husbandry equipment |
Loose the screw on the arm to adjust the float position and achieve
the horizontal and vertical installation.
Each of install method will not affect the performance.
1.If the body and pipe joint leak water, please check water tape is
wrapped and the pipe joint is tighted.
2.The Strength should suitable when tight and fix the float valve,
too much excessive strength will damage the valve.
3.Please check the water inlet filter regularly and remove the
garbage out in time.
4.Please do not use the cleanser which will cause damage when clean
the float valve.
