Overview
The DM542 is a new generation high-performance digital stepper
driver based on DSP with an advanced control algorithm. The motors
driven by DM542 can run with much smaller noise and much less
vibration than other drivers in the market. The DM542 possesses the
feature of lower noise, lower vibration, and lower heating. The
DM542’s voltage is DC 20V-50V. It is suitable for all the 2-phase
hybrid stepper motors whose current is less than 4.20A. There are
15 kinds of micro step of DM542. The maximum step number of DM542
is 25600steps/rev (microstep is 1/128 ). Its current range is
1.0A-4.20A, and its output current has 8 stalls. DM542 has
automatic semi-flow, over-voltage, under voltage, and over-current
protection functions.
Common indicator of 2 phase stepper motor driver
| Phenomenon | Reason | Solution |
The red indicator is on. | 1. A short circuit of motor wires. | Inspect or change wires |
| 2. The external voltage is over or low than the driver’s working
voltage. | Adjust the voltage to a reasonable range |
| 3. Unknown reason | Return the goods |
What are stepper motors and stepper drives?
Stepper motor is a special motor specially used for precise control
of speed and position. It runs step by step at a fixed angle
(called "step angle"), so it is called stepper motor. Its
characteristic is that there is no accumulated error. It receives
every pulse signal from the controller, and the motor runs at a
fixed angle under the drive of the driver, so it is widely used in
various open loop control.
The stepper driver is a power amplifier that can make the stepper
motor run. It can convert the pulse signal sent by the controller
into the power signal of the stepper motor. The speed of the motor
is proportional to the pulse frequency, so the control pulse
frequency can be adjusted accurately. Accurate positioning can be
achieved by controlling the number of pulses.
What is driver segmentation? What is the relation between the speed
of stepping motor and pulse frequency?
Due to the unique structure of the stepping motor, it is marked
with "inherent step Angle of the motor" when leaving the factory
(for example, 0.9°/1.8°, indicating that the rotation Angle of each
step of the half-step is 0.9° and that of the whole step is 1.8°).
However, in many precision control and occasions, the whole step
Angle is too large, affecting the control accuracy, and vibration
is too large, so many steps are required to complete a motor
natural step Angle, which is the so-called subdivision drive, the
electronic device that can achieve this function is called the
subdivision driver.
Applications of stepper motor driver
It can be applied in a variety of small scale automation equipment
and instruments, such as labeling machine, cutting machine, packing
machine, drawing machine, engraving machine, CNC machine and so on.
It always performs well when it is used in equipment which requires
for low-vibration, low-noise, high-precision and high-velocity.
